wont, start,change punp,not getting gas
No, 97-03 F150's have a 5x135 lug pattern.
The first thing I would check is the factory immobilizer, try another key if you have one.
Yes it did.
If it is an aftermarket item it could be a by-pass switch for a remote start.
i need full wiring diagram on a 1982 ford f150 xlt with the 351 clevland 5.8 ltr
If your Ford Bantam is not starting, you might have a dead battery or a problem with the starter. You might also have an empty gas tank or clogged fuel filter.
What year? On older models, it could be the solenoid that has gone bad. On newer models, it could be the switch, or the starter itself. If you have an alarm system, it could be interfereing with the start circuits.
The starter have a bad rep But you can replace the relay and clean the connections but 9 out of 10 times it's the starter itself.
There is no OBDII connector on 1993 F150. Didn't start until 1996 (97 model).
You wouldn't happen to be using too heavy of an engine oil ? What grade of engine oil are you using ?
Could be tune up time.
Well of course it could be, but not likely given the scenario just described.