0
What else can I help you with?
How do you replace a starter on Chevy Trailblazer?
Where is the starter on a 2004 Chevy trailblazer.
Have 351 windsor two of them a 1986 and 1990 both with same problem when the starter engages it slips on the fly wheel replaced starter and fly wheel and it still does it never had this problem onford?
I'm not sure what you mean by "slips". Is the starter making a grinding noise or does the starter sound like it is missing the flywheel completely? My first thought was a bad starter drive (part of the starter) but if you replaced the starter with a new one it shouldn't be that.
What would cause a car to whine and crank when trying to start it after 8 or so idle hours you have replaced the starter it is a Chevy s10 2001?
Did you follow the starter alignment instructions when you replaced the starter? Are you getting oil on the Bendix? That could cause the starter gear to engage slowly. It is possible that the replacment starter has a problem. Also, if the previous starter had the same problem it could have damaged the gear on the flex plate.
2004 Chevy Trailblazer will not start?
replace the starter
How do you start a 1998 polaris trailblazer 250?
There are two ways to start a 98 Trailblazer. One way that you can is if you have a battery in your atv and the starter doesnt need to be replaced, you turn on the key then make sure the run switch is on and then press and hold the starter button on the left side of the handle bar or if your starter is out like on mine, you will have to use the pul start on the right side of the atv and if you have the airfilter on and have gas and oil in it, it will start with one pull.
Where is the starter solenoid on a 2002 Chevy Trailblazer?
Attached to the starter itself. However it is not removable. Have to buy a whole new starter.
When I replaced a fuel pump in my 97 blazer it still won't start What could be the problem?
Dead starter?
Why did your 1992 Geo tracker 4 wd crank and then cut off and wont crank back?
crank sencer When I had the same problem it was the starter solenoid. It is built on the starter so you have to replace both. After the starter/solenoid was replaced I had no more problems. P.S. If you take it to most major auto parts places they can check the starter but not the solenoid mine showed good but after I replaced it I never had that problem again.
What is wrong with a car when it wont start just make a grinding sound?
It can be a defective starter assembly that causes this problem. There are two parts to a starter assembly: the starter motor and the starter solenoid. The offending culprit is usually the starter solenoid, and it should be replaced.
What is wrong on a Chevy TrailBlazer 2003 that does not start all the time and the computer does not show that there is a problem and sometimes when I turn the key the dash lights come on. no starter.?
Could be battery, battery connections, starter, starter connections, neutral safety switch. I would check those in that order.
I replaced starter 6 times in 6 month period and have replaced the flywheel I am still going through starters I have a 1971 350 camaroNoone can figure out why this is happening Can you help?
If you have headers put a heat shield over the starter. That is what fixed my 84 C-10 starter issues. If it is a gear alignment problem try shimming. If it is a electrical problem try the heat shield.
You replaced the starter and its grinding how do you fix that?
I replaced the starter but it makes a grinding nose how do i fix it
