0
I replaced starter 6 times in 6 month period and have replaced the flywheel I am still going through starters I have a 1971 350 camaroNoone can figure out why this is happening Can you help?
Wiki User
∙ 13y ago
If you have headers put a heat shield over the starter. That is what fixed my 84 C-10 starter issues.
If it is a gear alignment problem try shimming. If it is a electrical problem try the heat shield.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Will a high torque starter work on a flat spotted flywheel Cause the regular starters just hit the flywheel.?
The answer to the question is no. If the flywheel is ground or damaged it needs to be replaced.
1971 350 camaro i have gone through 6 starters and have replaced the flywheel still going through starters can you help?
if the engine has high comprshen it will eat starters
1995 Mercury Villager and it keeps eating Starters but its not the FlyWheel was told the FlyWheel is Reverseing what would cause that to happin?
i have a 95 Mercury Villager,,it keeps eating Starters,,except its not the Flywheel,, Just found out that the Flywheel has been Reverseing,,, what would cause that to happin...Help...
1971 camaro 350 automatic transmission i have replaced the flywheel and gone through 6 starters no one can figure out problem can you help?
bad ground wire or not enough ground
Why would starters on a 1984 Mercury Capri 3.8l whirr loudly even after you bench-tested three starters?
Just a suggestion Check the flywheel
Where is the starter on an Acura 1998 3.0 CL?
the same place all starters are located against the flywheel.
1984 ford ranger just had the clutch replaced when you got it back the starter sounds like they left a tool in there you have battled with the repair shop since you have been through 3 starters since?
it may be that your flywheel is loose, and the starter is jumping the teeth,
Problems with starters of transit vans?
yep bad starters but a lot of the trouble is caused by the two part flywheel which has anti shock springs in it if they are gone it will eat starters but worse can damage the gearbox too the best cure if this is the case ford still sell the old type solid flywheel for the new vans and this cures the problem just google flywheel transit and you will find a lot of sites with unhappy ford transit customers but other than that they don't give much other trouble
Will any Chevy starter fit both 168 and 153 tooth flywheels?
No. Chevy uses a number of different noses for their starters. The size of the flywheel and year and model of engine determine what nose is needed. The 153 tooth flywheel is smaller in diamaiater than the 168 tooth flywheel. If you want to use a starter from a 168 tooth flywheel on a 153 tooth flywheel the nose from the smaller flywheel starter will have to be exchanged onto the larger flywheel prior to using it.
You have a 1993 Camaro Z-28 that has gone through 6 starters in little over a month the flywheel is good Shims were tried and failed Could the car being out of time be a cause?
Its probably a bad flywheel
What parts make up a starter motor?
Modern starters include: * the starter motor... a motor * the solenoid, which engages the electrical current to the starter AND engages the gear to the flywheel. * the bendix, which is a gear that engages the starter to the flywheel.
Can you use a starter off of a 1987 2 9 v6 bronco II to replace the starter on an 1992 ranger xlt 4 0 v6?
The starters will not interchange. The starters do not align with the bolt holes and flywheel.
