It is illegal to disable the driver airbag, and also a very ignorant thing to do. Disable that airbag and have an accident where you are injured, and your insurance company could refuse payment for the injuries you may suffer. Air bags save lives and I will not help you on this one.
Im in the same boat as you are but i think you have to disable the airbag and drop the steering wheel to reach it
AIRBAG WARNING: Before you remove any steering wheel parts on an airbag equipped car it is important that you disconnect the negative battery cable to disable the airbag system. A loose airbag deploying directly in your face can cause serious injury, and could possibly kill you DEAD.Having said that, I'm not sure exactly the procedure on a Seville, but I'll give you a basic run down of how to take off most steering wheels.1)Disconnect negative battery cable2)Determine how airbag module is attached to steering wheel. The airbag module is in the front center of the steering wheel and is the part of the steering wheel you see. It likely has a vehicle emblem right on it. There may be plastic covers on the side or back of steering wheel that hide airbag retainer nuts. Some airbag modules are simply held in by clips and can be pulled out. Once you determine how the airbag is fastened remove it from the steering wheel. There will be an electrical connector to the airbag (usually yellow). Carefully disconnect electrical connector and set airbag aside.2)Disconnect horn wire, and any other electrical wires used inside the steering wheel. There should be connectors for all wires.3)NOTE:ENSURE STEERING WHEEL IS POINTED STRAIGHT AHEAD PRIOR TO REMOVAL. At this stage you should have access to the steering wheel nut. Remove the steering wheel nut.Some steering wheels will simply come off at this stage. However most wheels must be pressed off. Use a steering wheel puller to pull wheel. A puller set can be rented at most auto parts stores if you don't have one.4)CLOCKSPRING WARNING:Behind the steering wheel there is a component known as a clockspring. It houses the wires for the airbag and other steering wheel electronics. It allows the steering wheel to spin and maintain electrical connections. It is important that the clockspring or wheels are not turned while the steering wheel is out. If the clockspring is turned too many times over it will break causing steering wheel electronics not to work(and an expensive repair). It must remain centered at all times.
To disable the driver side airbag on a 1997 Jeep Grand Cherokee, you should first disconnect the vehicle's battery to prevent any accidental deployment. Next, locate the airbag module under the steering wheel and carefully disconnect the airbag connector. It's important to handle the airbag with caution and ensure that you follow safety protocols, as improper handling can lead to injury. Always consult your vehicle's service manual for specific instructions and consider seeking professional assistance if you're unsure.
The clock spring is located inside the steering wheel behind the airbag.
You've got to disable the airbag and remove it, then pull the steering wheel, .... go to www.autozone .com for more detailed instructions. hope that helps. Ron
To remove the airbag from a 1997 Cadillac Eldorado, first disconnect the negative battery cable and wait at least 10 minutes to ensure the airbag system is deactivated. Then, locate the airbag module on the steering wheel, usually secured by screws or clips; remove these fasteners carefully. Gently pull the airbag away from the steering wheel, disconnect the wiring harnesses attached to the back, and ensure you handle the airbag with care to avoid accidental deployment. Reassemble any components in reverse order once the airbag is removed.
look for the airbag fuse in the fuse box.
To disable the door lock alert on a 1997 Town and Country, locate the fuse panel underneath the steering wheel and disconnect the orange and white wires. Then, unplug the alarm system.
To remove the airbag coil (also known as the spiral cable) on a 1997 Pontiac Sunfire, first disconnect the negative battery cable to ensure safety. Then, remove the steering wheel by unscrewing the retaining nut and using a steering wheel puller if necessary. After that, detach the airbag module by unfastening the screws and disconnecting the wiring harness. Finally, you can access and remove the airbag coil from the steering column by carefully releasing any retaining clips and pulling it out.
It is illegal to disable an air bag without written permission from the NHTSA
You have to remove the steering wheel and driver airbag to replace this multi function switch....trust me I had to do it.
how do you fix play in a 1997 mercury mountainer steering wheel