0
What else can I help you with?
How do I change a 95 altima antenna?
In the trunk of the car, where the antenna is on the outside, there are pretty flimsy panels that line the trunk. Pry the circular clips out with a flat head screwdriver but be careful not to break them because the more you lose, the looser those panels are when you put it all back together. There will be a box that houses the antenna behind the obvious panel in your trunk, where the antenna is on the outside. There are a few bolts that secure the box to the car, and the antenna unscrews from the outside (even in the down position) so you can remove the box from the inside. There is a circular dome shaped piece of plastic that the antenna sits in on the outside of the car when it is retracted and it will unscrew with a little finesse. The wires to the antenna are connected with a harness, just like most other wiring in these cars, so use a flat-head screwdriver to disconnect the harness. You will need to disconnect both the power to the antenna and the line from the antenna to the stereo. It may take some maneuvering, I don't think it just slides out but it is replaceable. Assembly is the same as taking it apart, but if you need more help, I always refer back to a manual (sold in car part stores for $15-20).
Power antena stays on 1990 Cadillac Fleetwod?
Stays ? You mean doesn't work ? Most common problem is just sticking, telescopic and power antennas should be lightly oiled after each wash. Try very carefully to draw it out by hand when a friend turns the power on on the radio (on the automatic antenna; if it is out and doesn't go in, then don't try to push it in - You probably just will kink the antenna). Check the fuse next, then the rest of the analyses nearly requires taking the antenna out from under the fender and use the voltmeter to check things.
How do you disconnect the battery on a 2003 Pontiac Aztek?
by taking the cables out
When Replacing a fender on a 1999 dodge Dakota is there a special glue the manufacturer uses that requires a special tool when taking the fender off?
no...you have to take out all the water cannister, the computer, the air box horns etc....
How do you install a stereo in a 1998 Chevy Cavalier?
take the old one out by opening the glove compartment and taking the two screws out and take that part of the dash off and take the two screws off the stereo and disconnect the antenna and wire harness buy a installation kit and a antenna adapter and a wire harness and match the wires from new stereo to the wire harness the instructions are all there with the kit i think any store that sells stereos has these kits it will only take about about hour and a half
How do you remove a water pump from a 1997 Nissan Altima without taking out the AC pump?
You don't have to disconnect the A/C compressor, but you do have to unbolt it and drop it out of the way. There are four bolts facing the front of the car holding the compressor in place.
After trying to start and engine what would cause it to keep turning over even when you disconnect the ignition wires all to gether?
your starter is bad, has a short in it, or is sticking, you might be able to get the starter tested without taking it off your vehicle.
Taking off a fender on a 1998 Expedition xlt?
To remove the fender on a 1998 Expedition XLT, start by disconnecting the battery to ensure safety. Then, remove any screws and bolts securing the fender, typically found in the wheel well, along the top edge, and under the hood. Carefully pry the fender away from the body, being cautious of any clips or additional fasteners. Finally, lift the fender off and set it aside, ensuring not to damage any nearby components.
How do you remove the driver side front fender on a 1995 Lincoln Mark VIII?
LH side or RH side take the plastic shield or inner fender(mud gard) that is below the fender then take the signal lamp off ,after that start taking the nuts that holds the bumper cover and fender close to the tire it could be an 8 or 10 ml socket ,open the door and you'll see 2 more fender bolts take those off also ,under the car where the fender ends it has two more bolts take theme off then on the upper seccion of the fender it has more screws. good luck!
When was Change the World Without Taking Power created?
Change the World Without Taking Power was created in 2002.
How do you remove 2006 Toyota Highlander fender?
To remove the fender from a 2006 Toyota Highlander, start by disconnecting the negative battery terminal to ensure safety. Next, remove any screws and clips securing the fender, typically found along the top edge, inside the wheel well, and at the front of the door. Carefully pull the fender away from the body, taking care not to damage any attached components. Finally, if necessary, detach any electrical connections or brackets before fully removing the fender.
What is the first step when taking a computer apart?
The first step when taking a computer apart is to power it off completely and unplug it from the power source to ensure safety.
