To replace the Sunfires fender, you will need to disconnect any wiring (marker lights) connected to the fender. With a helper, unbolt the fender then set it off. Check for any tack welds that may be holding the fender on as well.
Try looking in the trunk on the driver's side inside fender underneath the carpeting.
How do you replace passenger side fender on a 1998 pontiac bonneville se
TAKE THE PASSENGER SIDE HEAD LIGHT OUT. YOU WILL SEE IT IN THE FENDER.
If it's anything like my '96, it's located on the side of the dashboard. You have to open the driver's side door to see it. There are also some fuses and relays under the hood on the driver's side fender well.
According to my Hayes repair manual the PCM is located inside the right front fender.
The ECM is located on the driver's side, under the hood on a 2003 Pontiac Montana. It is on the driver's inner fender.
Removing and replacing the fender on a 1999 Pontiac Sunfire typically takes about 2 to 4 hours, depending on your mechanical skill level and the tools available. The process involves removing bolts, clips, and potentially other components like the wheel and inner fender liner. If you're experienced and have the right tools, it may take less time, while a novice might take longer. Always ensure you have a repair manual for specific instructions related to your vehicle.
Turn the wheels all the way to the right. Look between the back of the driver side wheel and the fender. You will see the reverse light switch just above the transaxle.
There are two places, that I know of, where fuses are located. One is the fuse panel which on my older model, is at the left side of the dash. You have to open the driver's door to access it. The other place is under the hood on the driver's side fender well.
The engine control unit (ECU), or computer, for the 1995 Pontiac Sunfire/Chevrolet Cavalier is located on the right-front side of the vehicle. Directly to the edge of the front frame bar (behind the bumper), and the right-front edge of the fender will be the ECU.
Don't quote me here, but I think it's under the hood on the driver's side fender well where the other relays are.I'm sorry but I don't have my Haynes manual right here or I'd try to check further for you.
To remove the driver side fender on a 2000 Pontiac Grand Am, start by disconnecting the battery to ensure safety. Then, remove the screws and bolts securing the fender, which are typically found along the top edge, inside the wheel well, and at the front of the fender. You may need to remove the wheel and inner fender liner for easier access. Finally, gently pull the fender away from the body, taking care not to damage any attached components.