Removing and replacing the fender on a 1999 Pontiac Sunfire typically takes about 2 to 4 hours, depending on your mechanical skill level and the tools available. The process involves removing bolts, clips, and potentially other components like the wheel and inner fender liner. If you're experienced and have the right tools, it may take less time, while a novice might take longer. Always ensure you have a repair manual for specific instructions related to your vehicle.
To replace the Sunfires fender, you will need to disconnect any wiring (marker lights) connected to the fender. With a helper, unbolt the fender then set it off. Check for any tack welds that may be holding the fender on as well.
yes
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt
You must first remove the trunk door facia. (This is the part with the "Pontiac" lights in it.) Then you can get to the bulb to replace it.
how to remove key cylinder on 98 sunfire
I need to know how to remove a rear wheel speed sensor on a 2002 Pontiac Sunfire
remove both hoses and replace the o rings
Remove the serpentine belt. Tensioner is below Alternator. Remove the three mounting bolts on the tensioner baracket assembly. Replace entire unit.
Remove the panel under steering wheel. There will be 2 flashers. Replace one on right.
To replace the dashboard lights in a 2005 Pontiac Sunfire, first, disconnect the negative battery cable for safety. Remove the dashboard trim panel by unscrewing any screws and gently prying it off. Then, locate the bulb sockets on the back of the gauge cluster, twist them counterclockwise to remove, and replace the burned-out bulbs with new ones. Finally, reassemble the dashboard and reconnect the battery.
With a sledge hammer and a bottle of febreeze
The center console is held on by several mounting screws. To remove it from a Pontiac Sunfire unscrew all of the mounting hardware. The center console will then be able to be pried off.