- Hi all it was a minor problem a metal tab that was bent probably caused by the frost built-up in they parking area of the wipers did not cost me a dime found the problem by accident
there are bolts on the top and bottom arms that hold the door to the van on the door side of these arms that can be loosened to adjust the door then tightened back but for me the top bracket is bent i will have to replace the arm
To adjust the wiper linkage on a 1997 Volvo 850, first ensure the wipers are in the "off" position. Remove the plastic cover from the wiper motor and disconnect the wiper arms. Then, manually reposition the wiper linkage to ensure it sits correctly in its resting position. Finally, reattach the wiper arms, ensuring they are aligned properly, and test the wipers to confirm the adjustment is successful.
someone put the wiper arms on the wrong notch on the wiper posts. take one off and adjust it
The 2002 Pontiac Montana has hook-end wiper arms on both front and rear. See the Sources and Related Links section below for wiper blade installation videos and correct attachment/length wiper blade sizes. Also, if you purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through. Very simple.
beneath the driver's side wiper arm. you must remove both wiper arms and the black cowl underneath. What issue are you having with it?
Wiper arms on a 96 Buick Skylark can be adjusted. This can be done by flipping open the plastic snap cover at the bottom of the wiper arm. Loosen the ratchet and remove the nut. Then adjust the wiper arm. Put back the nut and tighten the ratchet.Ê
It is under the wiper arms.It is under the wiper arms.
Be careful on this vehicle. If the arms are standard hood, use the link below in Sources & Related links. If it is a reverse hook, the wiper blades are special.
To replace the wiper motor on a Pontiac Aztek, first disconnect the negative battery cable for safety. Remove the wiper arms by taking off the retaining nuts and gently pulling the arms off the splines. Then, access the wiper motor by removing the screws or bolts securing it in place, disconnect the wiring harness, and replace it with the new motor. Reassemble everything by reversing the disassembly steps, ensuring all connections are secure.
The wiper motor on a 1997 Pontiac Grand Prix is located on the driver's side, beneath the windshield wiper assembly. To access it, you typically need to remove the windshield wiper arms and the plastic cowl cover that sits at the base of the windshield. The motor is mounted to the firewall and connected to the wiper linkage. If you're servicing it, ensure the battery is disconnected for safety.
The wiper arms have disconnected from the wiper motor. How do you reconnect them?
if your standing in front of the van they are located straight ahead right under the wiper arms