ETS is connected to your ABS. ETS is a traction control and is linked to your ABS so to get your ETS light off you'll probably have to fix your ABS to get the light off. On mine, fixing a broken wire on my ABS plug which runs into the hub fixed my problem.
i have a 2001 pontiac sunfire antitheft problem will not start anttheft light flashs on dash i can turn motor over buy jump starter but will not start
headlights and dash lights in 2001 sunfire wont turn on.
To change the license plate light on a Pontiac Sunfire, first remove the cover over the bulb with a small screwdriver. Gently push on the bulb and turn 1/4 turn to remove the old bulb. Insert the new bulb and snap in the cover.
To disable the theft system on a 1999 Pontiac Sunfire, you can try resetting it by disconnecting the battery for about 10 minutes and then reconnecting it. If that doesn't work, you may need to use the key in the ignition and turn it to the "On" position for about 10 minutes until the security light turns off. If issues persist, consider consulting the owner's manual or a professional mechanic for further assistance.
Fill your coolant reservoir and the light should turn off. Do it soon or your engine may over heat.
I think I'd replace the turn signal flasher. It's just a little bi-metal switch and can go bad easily.
under the dash
Yes it will.
you did not turn the switch off they are not automatic
To clear the anti-theft warning light on a Pontiac Sunfire, first, ensure that your vehicle is in the "On" position without starting the engine. Insert the key into the ignition and turn it to the "On" position for about 10 minutes until the light turns off. After that, turn the ignition off and then start the engine to see if the light remains off. If the warning persists, consult the vehicle's owner manual or a professional mechanic for further assistance.
etc button on left of dash driverside Depends on year of car - I've also seen it on the gear shifter.
You can access the backup light on your Pontiac from the trunk compartment. Remove the backup light cover. Take hold of the backup light connector, push in and turn at the same time. Do the same with the backup lightbulb. Reverse the process to install the new lightbulb.