Don't do that!It's a major mistake to that!The airbag is a safety device.
No,the driver-side airbag premiered on the 1990 Corvette as standard.Also the passenger-side airbag premiered on the 1994 Corvette as standard too.
No
You must first remove the airbag. This has to be done following directions from a service manual. If you do it incorrectly the airbag can be set off. If your horn isn't working it is probably the spring loaded button in the steering wheel behind the airbag. The plastic keeper breaks and the spring won't hold the button down.
== == No,the driver airbag arrived in 1990 as standard and the passenger airbag in 1994 as standard too.
To remove the knee bolster in a 1995 Corvette without deploying the airbag, first disconnect the car battery to prevent any electrical issues. Next, locate and remove the screws securing the knee bolster; these are typically found along the edges and may be hidden under trim pieces. Carefully detach the bolster, ensuring you don't disturb the airbag wiring. Once removed, you can safely clean out the mouse nest and reassemble the bolster afterward.
No, not until the 1994 models.
1980 corvette , how to remove speedometer
1990 A new Corvette ZR-1 model debuts and a driver-side airbag becomes a standard feature.
According to the used part interchange, 1999 through 2004 can be sold for the same car. Good luck
Don't do that!The airbag is a safety device which can save the life of the passenger in case of an accident!However,as the Corvette is a 2-seat car,if you are talking about a child,I strongly recommend you to install an aftermarket Passenger Airbag ON-OFF switch.That is possible even for older car models.Contact a Chevrolet dealer.
How do you remove the bottom front right airbag on a 2011 ford fiesta.
Drive and hit a brick wall, the airbag will deploy. Then remove it.