0
You must first remove the airbag. This has to be done following directions from a service manual. If you do it incorrectly the airbag can be set off. If your horn isn't working it is probably the spring loaded button in the steering wheel behind the airbag. The plastic keeper breaks and the spring won't hold the button down.
What else can I help you with?
Why does your 1998 corvette horn beep intermittently?
I quess is that the spring plunger that is behind your horn button is defective. Remove the steering wheel to replace it.
Where is 1982 corvette horn located?
The 1982 Corvette has two horns. both are located in the center under the front end, just in front of the radiator.
How do you replace the horn on 1996 Chevy Corvette?
Begin by removing the wiring harness from your 1996 Chevy Corvette horn. Remove the horn retaining bolts. Reverse the process to install the new horn.
Horn will not work on your 1991 corvette what else could it be besides the relay or horn button?
Broken Or Disconnected Wire To The Horn. Check For Voltage When Horn Button Is Pushed At The Wire After Removing It From The Horn. On A Vet Probably Not Grounded.
How do you replace the horn button in a 1992 Bonneville?
You can replace the horn button on your 1992 Pontiac Bonneville by removing the center steering will cover. Remove the horn button retaining screws. Remove the horn button wiring harness. Reverse the process to install your new horn button.
How do you remove a 1989 corvette horn button?
Squeeze the horn button at the top and bottom with your fingers and thumbs and pull. It takes some strength. Be careful when it releases as there is a wire and connector attached which can be damaged if you pull it too far. The horn buttom is held in place by four steel spring type clips located at 11am, 1pm, 5pm and 8pm. Good luck.
How do I remove the steering wheel from your 1986 300zx 2 2?
peel the horn button's vinyl cover off first. then unscrew the horn button off. peel the horn button's vinyl cover off first. then unscrew the horn button off.
Where is the horn on a 2008 Corvette?
On a 2008 Corvette, the horn is located in the front of the vehicle, specifically behind the front grille. It is mounted on the driver's side and can typically be accessed by removing the grille or the front fascia for replacement. The horn is an electric type, which produces sound when activated by the steering wheel button.
How do you fix a horn that doesn't work on a 2000 Chevy Malibu The relay and fuse are both good?
first remove wire to horn. see if power is going to horn when horn button is pushed. if it does its a horn problem, if not it is probably in the horn button itself.
How do you replace the ignition switch on a 1982 Mercedes 300SD?
To replace the ignition switch on a 1982 Mercedes 300SD, disconnect the battery and remove the horn pad. Locate the wire behind the horn and remove.
How do you remove a horn button on a 1970 vw beetle?
If it is the same as my 68, the horn button is held in place by a rubber o-ring under the button. carrefully work a thin, flat screw driver under the edge of the horn button and TWIST. Be careful not to chip the button. This should pop out the horn button.
Where is the horn relay located on a 1982 corvette?
You can find the relay on the drivers side under the dash near the fuse box. The easiest way to get to it is to remove the heat/ac duct. It just has a couple screws. The relay will just pull out.
