answersLogoWhite

0

There are about 4 to 5 screw that you have to take out from the consle. I know there are 2 little allen wrench screws that are under the gears cover, one under console armrest, and 2 behind the face of the astray and heat/ac area, and I think you should beable to take out the console without any problems. There's a chance you might run into more screws, but, i dont know. I've never taken mine out yet. Please make sure you label where your screws went, if not, its going to be difficult to put it together.

User Avatar

Wiki User

∙ 13y ago

What else can I help you with?

Related Questions

Where is the Climate control unit located on a 98 Lincoln mark viii?

Center dash above the console.


Where is the data line connector on a 98 Mitsubishi eclipse gst?

under the driver side dash next to the center console.


What motor will fit in a 98 Malibu?

Same size as you remove, If you don't want to change a lot of things


Where is the actuator for 98 Chevy Blazer?

the temperature control actuator is on top of the heater box under the dash. you have to remove the dash to get at it. a repair manuual will show what screws to remove


How do you change a crank sensor on a 98 Malibu?

remove power steering puimp remove power steering puimp this is were cam sensor is!! under pump.


Is gas tank easy to repair or replace on a 98 Malibu?

fairly simple to remove and replace. most shops can remove in 30 min or less.


Where is the data port located in 98 Mitsubishi eclipse?

data port is just under the dash on the drivers side toward the center console.


How do you take apart the 98 maxima dash to put lights in the dash?

http://www.geocities.com/amixam69/nissan/dash/ go to that site and it gives you step by step instructions on how to remove your dash.


OBD port on a 98 Tacoma?

The 1998 Tacoma OBD 2 port is on lower edge of dash; next to console; connector faces down


Will 1998 Malibu wheels fit a s10?

wondering if 98 chevy malibu wheels will fit a 98 gmc sonoma?


OBD port on a 98 Ttacoma?

The 1998 Toyota Tacoma OBD 2 port is on lower edge of dash; next to console; connector faces down


Where is 98 Nissan Sentra ecm located?

The ECM (Engine Control Module) is located under the dash panel, in front of the center console, and to the right of the accelerator pedal.

Trending Questions
What size bobbins does a brother ls-2000 use? How do you reset the keypad on a 2000 Expedition? Are parts for a 1995 and 1997 Lincoln Continental interchangeable? What is the normal oil pressure of a 2004 1500 5.3L silverado? What is the best way to replace the fuel pump for a 1996 Dodge Ram truck. Should I drop the gas tank or cut a hole in the bed of the truck for access? Where is PCV valve located on a 2000 Lexus GS300? How much horsepower does a stock Pontiac Fiero GT have? What is the spark plug wiring for a Pontiac 403? What dealerships in the US offer discounted Jeeps for sale? What would cause an AC unit to not take a charge Is there a filter that needs to be cleaned prior to charging an AC system on a 1984 Ford Bronco 2? How air brakes work on a dump truck? What is the base engine size of the 2010 Chevrolet Malibu? Where can i see 1996 suburban rear differential diagram pinion gear punctured cover but pin still there and no teeth broke off.No play in gears. What caused this? What kind of engine can you put in a 1990 hemi? How to change a serpentine belt on a 2000 Chrysler sebring? What transmission fluid does a Ford Mustang manual transmission take? How do you fix speedometer on 1993 dodge stealth? Heater and air conditioner selector in a 1989 Ford F-250 is stuck on the winshield position only cannot get cold air from regular vents or floor area? What is green and orange mixed together? Setting the timing on a 94 Geo tracker and there are 2 marks one by a marking that says 60 A and another by one that says 80 B which one would be the correct setting?