Are you asking about the shift lever on a column shift car or the console shift handle?
Yes.
It is glued on you have to replace the entire stick shift
Not sure on how to replace it, but it is located INSIDE your center console (which will need to be removed if you cant get to it by removing the shift boot) it is a pressure switch at the base of the handle...
drop the pan and replace it
Just push the clip off, I use a screw driver.
Yes, you can change the shifter handle. Remove the hairpin clip at the front side of the handle and lift the handle from the metal pipe.
http://www.dmctalk.com/showthread.php?t=8699
To access the shift cable on a 1986 Chevy Celebrity Eurosport, first, lift the vehicle and secure it on jack stands for safety. Remove the center console by unscrewing the necessary fasteners and lifting it out. Then, locate the shift cable at the base of the steering column or near the transmission linkage, depending on the specific setup. Disconnect the cable from its mounting points to facilitate any repairs or replacements.
That is called a shift shaft seal. Replace it.
The transmission uses a cable for linkage. If the car has consol shift the cable runs from the shifter to the transaxle. If it is a column shift the cable runs from a lever on the column to the transaxle.
On the 440T4 Automatic Overdrive transaxle the modulator is on the front of the case, A vacuum line leads to it from the intake manifold.
OnV6 4.3 with 4L60E transmission will faulty shift solenoid cause not to shift into high gear?