To release the emergency brake on a 1990 Corvette, locate the emergency brake lever between the driver's seat and the center console. Pull the lever up slightly to disengage the locking mechanism, then push the release button on the end of the lever while lowering it back down to its original position. Ensure the vehicle is in gear or park before attempting to release the brake. If the brake is stuck, check for any obstructions or consult a professional for assistance.
Usually located at the bottom of the emergency brake handle - may have to remove trim for access
To tighten the emergency brake cable on a 1990 Geo Prism, start by depressing the brake pedal. Next, locate the parking brake equalizer bar. Rotate both rear tires to feel the brake shoes slightly drag against the brake drum.
American Dreamer - 1990 Corvette Man 1-5 was released on: USA: 13 October 1990
Parking brake (also known as emergency brake) foot pedal expands the rear brake shoes against the brake drum holding or stopping the vehicle in an emergency situation not as effective as regular service brakes
Check your brake fluid level in your brake master cylinder in the engine compartment and see if it is down.
With the transmission in drive and the parking brake on.
the 1990 corvette had the LT-1 motor 300bhp and 340fpt that is the correct answer to this question!
I'm not a mechanic but I would start by checking the brake fluid level in the brake master cylinder in your engine compartment
Our 1990 Corvette convertible weighs 3301 pounds.
under dash on driver's side next to emergency brake pedal.
I found under the drivers dash on the brake pedal the brake light switch to be faulty. It can operate the tail lights but not the center brake light replace it. This was the case on my 90 vette.
== ==