0
1. Make sure ignition is in the OFF position.
2. Locate the programming connector in the trunk (drivers side). It is a plastic connector
with two wires leading up to it. The connector is not plugged into anything. You may
have to pull back trunk trim to access connector.
3. The programming connector should have two terminals. Connect both terminals with a
suitable jumper wire. Make sure the terminals remain connected throughout the
programming procedure.
4. Press the LOCK and UNLOCK buttons on the remote at the same time. In response, the
keyless entry module will cycle all door lock motors at once. This will indicate your
remote has been accepted and all existing remotes have been erased.
5. Repeat step 4 now for each additional remotes, including any exiting remotes. DO NOT
remove jumper wire in between programming of remotes.
6. Remove jumper wire and test remotes.
What else can I help you with?
How do you replace batteries in a 1998 Pontiac Sunfire door remote?
split the fob halfs and the battery will be on the backside of the board!
How do you re program key fob for Renault laguna1997?
How do I re program my key fob for renault laguna estate 1997?
How can you repair the door latch on your 1997 Pontiac sunfire. The latch is stuck in a position that does not allow it to close. the door does not close.?
Can you give us a bit more info? Do they lock from inside the car OK? Do they lock from your key fob? Inquiring minds ...... FriPilot
How do you program a key fob for a 1997 Chrysler Town and Country?
The dealers scan tool is required.
How do you program a key fob to a 2006 Chevy Malibu?
How do you program a key fob to a 2003 Chevy Malibu
How do you program a 1995 Lumina APV key fob?
To program any kind of key fob you have to take it to a dealership.
How do you program a 2004 Pontiac vibe key fob?
To program a 2004 Pontiac Vibe key fob, first, sit in the vehicle with all doors closed. Insert the key into the ignition and turn it to the "On" position (not starting the engine) and then back to "Off" five times within 10 seconds. The doors will lock and unlock, indicating the programming mode is active. Press and hold the "Lock" and "Unlock" buttons on the key fob simultaneously for about 15 seconds, then release them; the doors should lock and unlock again to confirm successful programming.
How do you program the anti theft radio on a 97 Pontiac sunfire?
Does this mean that you have disconnected the battery and now the radio won't work? And, you don't know the radio's code? If so, the dealership can hook you up, but it will probably cost you about $50. Check Ebay. There are guys who will sell you the procedure for about $10. I've read that this usually works fine. I did it for instructions to reprogram my key fob. Worked perfectly. FriPilot
How do you program a 2003 deville with a new key fob?
You don't. Take the car and the new fob to a caddy dealer or a locksmith who has the equipment to program it.
How do you program new key fob 2006 Chrysler town and country?
A scan tool is required to program a fob on a 2006 Chrysler Town and Country.
How do you change battery in key fob pontiac solstice?
Changing the battery in the key fob to a Pontiac Solstice is pretty simple. Just remove the back of the key fob, and take out the old battery. It takes a hearing aid battery, and they can be found at any chain pharmacy. Put in the new battery and replace the back to the key fob. It is now ready to go!
How do i Program fob key?
how do i program keyless remote for 2000 Buick LeSabre
