Inbetween the seats(top and bottom) you have to hold them apart you'll see some bolts you have to take out.
To repair a 1992 Toyota Tercel motor mount, first, safely lift the vehicle and support it with jack stands. Then, locate the damaged motor mount, typically found between the engine and the chassis. Remove the bolts securing the mount using the appropriate tools, and replace it with a new or refurbished mount. Finally, reattach the bolts, ensuring they are torqued to the manufacturer's specifications before lowering the vehicle back to the ground.
On the back of the engine block.
You have to remove the hole corner lamp so you can get to the bulb in the back, you just need a srew driver
on the back of the fuse box cover
the starter should be under the intake on the back of the motor.
Back side (firewall side)underneath near the bottom of the motor.
remove the rear wheel, undo the bottom bolt of the strut. inside the car remove the plasic paneling in the back covering the strut mount. unscrew both nuts and pull the strut out.
The starter on a '93 tercel, if you are looking from underneath the car, is directly to the left of the alternator. It is a fairly simple job to remove and replace the starter. If I can recall correctly the only thing that you need to remove is the intake support braket, but don't quote me on that.
The fuel pump is in the fuel tank. there is an access panel under the back seat to get to it.
in the fuel tank but access is under back seat... Remove back seat and fuel pump is easy to take out..
Remove Back seat to gain access to access hole. From there it should all be pretty simple to remove the pump from the tank.Remove wires from pump remove screws that retain pump. Reverse process to complete after inserting new pump.
To replace the headlight on a 1985 Toyota Tercel, first, open the hood and locate the headlight assembly. Remove the retaining screws or clips securing the headlight, then gently pull the assembly forward. Disconnect the electrical connector from the back of the headlight bulb, replace the bulb with a new one, and reconnect the electrical connector. Finally, reassemble the headlight assembly and secure it back in place with the screws or clips.