There are 6 coil packs on top of your engine, 3 on each side. They are black square units with one plug going to them, and two bolts holding them down. Remove the bolts and pull the coils out. The spark plugs are underneath. You will need a spark plug socket and an 8 inch extension to get them. Check out dodgeintrepid.net for tons of info on these cars.
.50 is the gap for a 2003 Dodge intrepid with a 2.7 moter .
Flush and replace the engine coolant. Replace the engine timing belt or chain. Replace the spark plugs & wires.
To replace the spark plugs on a 2000 Dodge Intrepid with a 3.5-liter engine, first, ensure the engine is cool. Remove the engine cover if necessary, then disconnect the ignition coil connectors and unbolt the coils to access the spark plugs. Use a spark plug socket to carefully remove the old plugs, inspecting them for wear, and then thread in the new spark plugs, making sure to torque them to the manufacturer's specifications. Reattach the coils and connectors, and replace the engine cover if applicable.
When changing out the spark plugs of a car, maintaining the gap is important to help the car run correctly. For a 1993 Dodge Intrepid the spark plug gap is 0.04 millimeters.
Under the coils on top of the valve covers
Disconnect the battery, remove the cables and boot covers, and remove the old spark plugs. Next, properly dispose of the spark plug, put in the new spark plug, attach the boot cover and wires, and connect the battery.
dude you need a tune up
Need to replace rear spark plugs
in the heads
I would replace the spark plugs after 50K, the wires and plugs again at 100K.
To change spark plugs on a 5.9 2002 Dodge Ram 1500, locate the old spark plugs. These are located at the end of the 8 wires inside the vehicle's bonnet. Remove the old spark plugs and replace with new.
Perhaps valve cover gasket is leaking oil onto plug area