0
Reset the error codes in the OBD computer. Autozone will read the error code(s) out for you for free and reset the OBD2 in your vehicle. The Service Engine Soon (SES) light came on because a sensor somewhere detected an out of tolerance condition. If this happens, the on-board diagnostics stores an error code (or possibly multiple codes), which illuminates the "Service Engine Soon" light. Resetting the codes will turn off the light, but may be only temporary. If the out of tolerance condition recurs, the code will again be stored and the SES light will light. You need to correct the underlying problem, which the code will help indicate. Some conditions, such as a random misfire, will clear on their own after 5 or 10 engine starts without the misfire. If this starts happening, it is time for a tune up - new spark plugs, fuel filter, air filter, etc. Editted the above, and added the following... Depending on your area, you can go to your local AutoZone, and they can sometimes reset your light. But in some areas, laws wont allow them too. My local AutoZone is like this, but if you hold their little code scanner, and ask them which buttons to press to reset it, its you that reset it and not them. Some will do this, but not all. Disconnecting the battery on a 1996 or newer vehicle no longer works for GM.
What else can I help you with?
How do you check the check engine light on a 2000 Oldsmobile intrigue?
With a scan tool.
How do you reset the change oil light in a 2000 Oldsmobile Intrigue?
To reset the change oil light in a 2000 Oldsmobile Intrigue, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Then, turn the ignition off and back to the "ON" position to check if the light has reset. If the light is off, the reset is successful.
Will an alternator off a 1999 Oldsmobile intrigue fit a 2000 Oldsmobile intrigue?
As long as the 1999 has the 3.5L engine, yes.
What is the engine oil capacity of a 2000 Oldsmobile Intrigue?
6 US Quarts.
Where you can find replacement for 2000 olds intrigue engine cradle?
Dealerships or junkyards.
On a 2000 Olds Intrigue where is the crankshaft position sensor located?
I have Olds Intrigue 2000 3.5L. Needed to replace faulty crankshaft sensor.3.5L engine has two of them. If engine is hard to start cold or hot and engine light is OK.Very common problem for this engine in Aurora 3.5 and Intrigue 3.5 is crankshaft position sensor. Which is located above and behind starter. Starter must be removed first.------------------------------------------------------------------------------------------------------------AnswerLower right hand side of the engine just above the oil pan. Theres a single bolt that holds it in.
How do you change the spark plugs on a 2001 Oldsmobile Intrigue with a 3.5 engine?
how do change the spark plugs and the coil pack on a 2000 Oldsmobile intrigue
How do you turn off change oil light 2000 intrigue?
To turn off the change oil light on a 2000 Oldsmobile Intrigue, first, ensure that the oil change has been performed. Then, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Finally, turn the ignition off and then back on to check if the light has reset.
Where is the low side service port on the 2000 Intrigue?
Behind the engine on the firewall, about dead center
What causes the check engine light to come on a 2000 Oldsmobile Intrigue blink and then go out and sometimes stay on for a while?
Have vehicle scanned to see if any codes are stored to determine the problem
How do you repair the console shift indicator light of a 2000 Olds Intrigue?
Just remove the console and you can get to it.
Is any other year GM engine compatible with 1999 Oldsmobile intrigue's 3.5?
The 2000 and 2001 Intrigue motors are it. The 02s are not completely the same, and the engine is so different from any other V6 GM made..
