To install a carburetor with an electric choke, first, ensure the engine is cool and disconnect the battery. Remove the old carburetor and clean the mounting surface on the intake manifold. Position the new carburetor on the manifold, aligning the gasket properly, and secure it with the mounting bolts. Finally, connect the electric choke wire to the ignition power source and reattach any necessary fuel lines and throttle linkage before reconnecting the battery.
Electric
The electric choke wire connects to the electric choke assembly on the carburetor. It's a round, black plastic assembly that is on the side of a STOCK carburetor. There SHOULD be a connection on the "HOT" side of the coil that lets you connect the choke wire.
To install a choke on a Rochester carburetor, first ensure the carburetor is clean and the engine is off. Remove the air cleaner and locate the choke housing on the carburetor. Position the choke plate within the housing and secure it with screws, ensuring the spring is properly oriented. Finally, connect the choke linkage to the throttle lever and adjust it as necessary for proper operation.
The carburetor has an electric choke that is possibly shorted.
It had an electric choke...chocks are for wheels.
An automatic choke is connected to the carburetor on small engines. To get a new automatic choke, a new carburetor will need to be purchased. It is easier to install a manual choke and less costly. Kits for this are sold at most automotive repair stores.
probably your electric choke . take note the electric choke of these caburator are activates when there is no courant and disactivated when there is courant
The choke light on a 1980 El Camino indicates that there is a problem with the electric choke on the carburetor. Causes range from loose wires to a defective choke.
When using an electric choke you will need to take the manual choke unit out and replace with the e.choke unit. Run power and ground to unit and then adjust to ambient tempature. Then test and tune
It is a carburetor where the engine coolant is routed through the choke system of the carburetor. When the coolant is cold the choke will close. As the engine coolant heats up it opens the choke.
You would want a source that is live when the key is in the on position.
depending on the manufacturer and year, it may be an electric choke