Don't know for sure it will work with a 2006, but here is the procedure for a 2004: # Close all the vehicle doors. # Insert the ignition key into the ignition lock cylinder. # Press and hold the door unlock switch. # While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF. # Release the door unlock switch. The doors will lock and unlock to confirm the program mode. # Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter. # Repeat the previous step to program up to four transmitters. # Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode. # Operate the transmitter functions in order to verify correct system operation.
The 1989 Buick Park Avenue does not come with a remote keyless entry. The keyless remote entry was not available till 1997.
Sell It!!
how do i program keyless remote for 2000 Buick LeSabre
Where remote module in a 98 buick regal
look on the back of you remote it has to have these numbers gm: 10246215 and model/fcc id: abo0204t if you need the program procedure please ask or post (locksmith)
Follow this link and you're good to go. Let me know if you have any questions. I've done this myself so I know how to do it. .ehow.com/how_7291758_program -remote-1997-buick-lesabre.html#ixzz1HA YkCKDX
How do i program my remote car starter / lawless remote
I found some great deals on keyless remotes on ebay. You can also order them from an auto parts store or you Buick dealer.
Buick Rainier was created in 2004.
To program a keyless remote for a 2006 Buick Lucerne, sit in the driver's seat and close all doors. Insert the key into the ignition and turn it to the "On" position without starting the engine, then turn it back to "Off" and remove the key. Repeat this process twice, then insert the key again and turn it to "On." Press and hold the "Lock" and "Unlock" buttons on the remote simultaneously for about 15 seconds until the doors lock and unlock, confirming successful programming.
To program the keyless entry remote you hold down the lock and unlock keys at the same time while within 10ft of vehicle to make sure you are within range of the remote for approx 10 seconds. the vehicle will alert with a short horn sound. if it does not respond, repeat. should only take 1-3 tries before it's done
Ign off, On the data link connector use a wire to jumper terminal #8 (black/white) wire to #4 (black) wire, Turn Ign on press and hold unlock and lock button on one transmitter locks will cycle, repeat for second transmitter, disconnect wire, should do it. That is basically correct but there are more detailed instructions with a diagram at the following site: How to Program a Replacement Keyless Remote on a 1997 Buick LeSabre | eHow.com http://www.ehow.com/how_7291758_program -remote-1997-buick-lesabre.html#ixzz1HA YkCKDX