0
What else can I help you with?
Do you need special tools to remove the crankshaft damper pulley on a 1996 Mitsubishi Eclipse?
on the Chrysler engine (420a) you do need a puller and installer to deal with the crankshaft dampener pulley.
Is the center bolt on the crankshaft damper pulley reverse threaded on a 1996 Chrysler LHS 3.5L?
No. Counter clockwise to loosen. It is very tight.
Where can you find the water pump in a 1996 Chrysler LHS?
The water pump is driven by the timing belt, to find it you must remove the serpentine belt, crankshaft damper, and timing belt cover.
Were is the crankshaft sensor on a 1996 olds LSS?
Does the LSS have a 3.8L engine? If so, the crank sensor is behind the crank pulley/harmonic damper.
Do you have to remove the air conditioner dryer to use the pulley on a 1996 deville?
No you don't have to remove the air conditioner dryer to use the pulley.........
What type of tool is needed to remove a power steering pump pulley on a 1996 ford wind star?
You will need a pulley puller to remove a power steering pump on a 1996 Ford Windstar.
On a 1996 s10 4.3 where is crankshalf sensor?
It is best reached from under the front of the vehicle. It is behind the vibration damper (bottom pulley) just to the passenger side.
How do you change the alternator belt on a 1996 Chrysler Sebring?
To change the alternator belt on a 1996 Chrysler Sebring, first, disconnect the battery to ensure safety. Loosen the tensioner pulley by turning the tensioner bolt with a wrench, which will relieve tension on the belt. Remove the old belt, then install the new belt following the correct routing path as indicated on the engine's belt diagram. Finally, reapply tension to the belt by tightening the tensioner pulley and reconnect the battery.
How do you acess the fuel pump to a 1996 Chrysler cirrus?
You have to remove the fuel tank.
How do you replace the water pump for a 1996 Chrysler town and country 3.8l?
# Drain Cooling System. Refer to procedure in this section. # Remove accessory drive belt. Refer to procedure in this section. # Remove right front lower fender shield. # Remove water pump pulley bolts and remove pulley. # Remove water pump mounting screws. Remove water pump. # Remove and discard O-ring seal. # Clean O-ring groove and O-ring surfaces on pump and chain case cover. Take care not to scratch or gouge sealing surface # Reverse steps to install. Edit- The 1996 Town and Country does not have a removable pump pulley. It is press fit on and does not require removal of any pulley bolts prior to removing the the pump mounting bolts.
How do you remove the power steering pulley on a 1996 GMC Sierra?
With a power steering pulley puller. Any attempt to remove the pulley without the proper tool will probably damage the pulley or the pump or both. Most auto parts stores will sell you the puller or rent you one.
On a Chevy 350 crank pulley there are three outer bolts and one center bolt - what should they be torqued to?
the center bolt is for the harmonic balancer , aka , vibration damper or torsional damper . the torque specs. i have are 1985 and before 60 ft-lbs , 1986 to 1995 70 ft-lbs , 1996 and later 74 ft-lbs . can't find any specs. for the pulley bolts .
