answersLogoWhite

0

After removing all the screws, I used a piece of metal (that I cut with tin snips years ago, to remove door and window crank handles) to snap the plastic retaining clips loose. Believe you can also buy a tool to remove the clips. If you're doing the driver/passenger doors, be careful near the speakers at the top of the doors. Didn't know how they were held and I broke the plastic pins. Should probably replace the clips with new ones before assembly. The old ones looked good but did not hold snug. Hope this helps.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you change the passenger window regulator on a 1999 Oldsmobile intrigue?

You would need to remove the door panel, and them remove the splash shield from the door. Once your inside the door, you would need to unbolt the regulator from the door and also the window. An instructional video has also been included that will show you a step by step process on how to do this.


How do you replace the window guide wires on a 1999 Oldsmobile intrigue?

Oh, dude, replacing window guide wires on a 1999 Oldsmobile Intrigue is a breeze. First, you'll need to remove the door panel, then disconnect the old guide wires and install the new ones. It's like changing shoelaces, but for your car window. Just make sure to follow a guide or tutorial to avoid any unexpected surprises.


How do you take door panel off a 2000 oldsmobile intrigue?

To remove the door panel from a 2000 Oldsmobile Intrigue, start by disconnecting the negative battery terminal for safety. Then, use a flathead screwdriver to gently pry off the plastic cover from the door handle to access the screws. Remove any screws securing the panel, typically located near the handle and along the edges. Finally, carefully pull the panel away from the door, releasing any clips, and disconnect any wiring harnesses for power windows or locks before fully removing it.


How do you replace the passenger side mirror on a 1999 Oldsmobile Intrigue?

You have to remove the door panel, this panel has a very large amount of plastic pins holding it on. There are three nuts holding the mirror on the door, undo the 6 pin plug first. Then the mirror will come off with the removal of all the nuts. Just reverse the procedure. There are screws behind the panel behind the interior door handle, and inside the area under the power window panel.


Where is the fuse box locateD for a 2001 olDsmobile intrigue?

It is on the side facing the pasenger door when you open the door


Location of 1999 Oldsmobile silhouette body control module?

Behind the right rear panel, behind the right sliding door.


Where is the Blend Door Actuator in a 1998 Oldsmobile intrigue?

http://www.youtube.com/watch?v=QKdDTupYOCM Its for a 1998 Buick Century, but I believe it is the same on the Intrigue


Why does driver door Auto door lock on a 1998 Oldsmobile intrigue?

its a feature on these cars that you can change if you want read your owners manual


How do you remove an interior door panel on a 1999 Mustang?

how do you remove a right door panel on a 1999 Ford Mustang?


How do you remove driver side door panel on 1999 Oldsmobile intrigue?

The whole door panel comes off by prying the bottom edges until the plastic retention clips pop loose, then pull up on the panel to lift it off the window sill. Some of the retention clips will likely break, so have a spare pack on hand for reinstallation. The inside door handle needs to be removed first. There is also a smaller panel on the door handle for the window and mirror switches. Remove that by prying up at the rear of the panel and then lifting it up and back. Be careful, as the plastic will be brittle and the teeth at the front of the panel may break. If that happens, the panel is pretty much ruined.


Where is the window motor for 1991 Oldsmobile 88?

inside the door panel


How do you remove an interior door panel on a 1999 Ford Mustang?

how do you remove a right door panel on a 1999 ford mustang?