0
To replace the ignition switch in a 1998 Oldsmobile 88, first, disconnect the negative battery terminal to avoid any electrical issues. Remove the steering column covers, then locate the ignition switch, which is typically mounted on the steering column. Disconnect the wiring harness and unbolt the switch, then install the new ignition switch by reversing the removal process. Finally, reassemble the steering column covers and reconnect the battery.
What else can I help you with?
Need copy of diagram to replace serpentine belt on 1998 Olds 88?
I found this information with a diagram of the serpentine belt. Hope it helps.
Do you need to take the motor mounts loose to replace your serpentine belt on your olds 1998 88?
all u have to do is take it out and then put it back in
Which Coil goes to the?
#3 Cylinder on a 1998 Olds 88
How do you replace ignition switch on 1994 olds 88?
To replace the ignition switch on a 1994 Oldsmobile 88, begin by disconnecting the battery to ensure safety. Remove the steering column covers to access the ignition switch, then disconnect the wiring harness and unscrew the switch from its mounting. Install the new ignition switch by reversing the removal process, ensuring it's securely attached, and reconnect the battery. Finally, test the new switch to ensure proper functionality.
How do you replace the ignition module on a 88 Ford Mustang?
88ford tempo
How do you replace a timing chain on a 1998 Oldsmobile delta 88?
How to change a timing chain in a 1998 Oldsmobile delta 88
How do you replace or repair a fuel pump in a 1994 olds delta 88?
In the fuel tank.
Speakers for a 1998 olds 88?
Front doors, "5 1/4", rear deck is "6x9".
How do you install a multifunction switch on a Oldsmobile?
1998 olds 88 turn signal left turn not working
How do you access the ignition cylinder in the drive shaft of a 1972 Olds Delta 88?
Steering wheel has to be removed. You need special tools.
How do you put transmission fluid in a 1998 Olds Delta 88?
Down same tube that holds trans dipstick.
1997 olds 88 turn signals burn but don't blink?
you need to replace the turn signil fuse
