I can remove the two Phillips head screws on the top of the trim ring. My manual shows two nuts on the bottom of the trim rings which I cannot locate. I found a nut and while trying to remove it the turn signal lens assembly was pushed out. Help please
Dark Brown for all parking and side marker lights.
On my 94 Explorer, you get access from the outside. The frame that holds the front side marker lamp and the parking lamp (but not the headlight) pivots out, giving you access to the front side marker lamp. Pop the hood, look under the front rubber flap near the headlight, and remove the 2 screws that hold the frame in place. Then, pull the frame towards the front of the vehicle, it will pivot out about 2 inches. Look inside the area that opened up, you'll see the plastic assembly where the lamp is mounted. Grab the assembly, push it forward a bit, turn the assembly a bit (I think counter clockwise), the assembly will pop out. Replace the lamp, and put everything back together.
left front is light gray(-) and tan (+) right front is light green (-) and dark green (+)
It is a light on the front of a car or truck that lights up the road.
It would depend on what year the truck was made.
autozone.com has online manuals you can access for free
A truck is normally driven from the front.
Yes as long as the truck is not a T100. The 92 and 93 model years were the same as far as the doors are concerned. The only difference you will see is between the 2wd and the 4wd. They had different marker lights in the front.
Unplug daytime running light module. It is located on driver side just under the front of the truck.
Remove the socket containing the bulb from behind the bumper. Twist the socket 1/4 turn counterclockwise and pull the socket out.
you can see the front of the truck in your rear-view mirror.
you can see the front of the truck in your rear-view mirror.