To add Freon to a 2005 Chevy Cobalt, first locate the low-pressure service port, which is typically near the accumulator on the larger diameter aluminum line. Ensure the engine is off and the AC is set to the maximum cool setting. Attach the refrigerant can to the low-pressure port and open the valve on the can while running the engine and AC. Monitor the pressure gauge on the refrigerant can and avoid overfilling; stop when the system reaches the appropriate pressure range.
to the low side
where do I add freon to my air conditioning unit on a 1997 chevy truck?
no
You always add freon using a set of gauges and you would use the low side (blue knob), if you are not using gauges then still use the low side service port but make sure that its a freon problem first...........
You can add Freon to your 1999 Chevy cooling system through the low pressure port. Connect your Freon bottle to the low pressure port and release the Freon into the system.
Freon is a very touchy thing to work with. The EPA bans its release into the atmosphere, so only experts and professionals know how to add and subtract Freon from the car safely. Take your car to a mechanic or a Chevy dealer for this.
To add transmission fluid to a 2005 Chevy Cobalt, first ensure the vehicle is on a level surface and the engine is running. Locate the transmission dipstick, usually found near the back of the engine, and remove it. Using a funnel, slowly add the appropriate type of transmission fluid through the dipstick tube, checking the level frequently to avoid overfilling. After adding, reinsert the dipstick and check for any leaks.
There is a fill hole on the top of the transmission.
The Cobalt is a closed system. That means you can not add trans fluid, it has to go to the dealer to get it done right. rev. this is not a closed system. you can add fluid on top of the trans there is a fill cap. best thing to do if your not sure is to drop the pan and change the filter and add 7 qts of fluid. Dex3
Where is the intake valve / connector to add fron to my 2005 Kia Optima, with a 2.7l ^-cyclinder?
The schrader valve on the low pressure side of the system.
This is what I did for my Chevy prism 2000, it works fine: http://www.id-usa.com/how_to_recharging.asp