answersLogoWhite

0

Idle speed is computer controlled and is not adjustable. If the speed is incorrect, there is a computer, sensor, or actuator failure.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Does a 1993 Chrysler new yorker have a Mitsubishi engine?

The 3.0L V6 is a Mitsubishi engine, all others are Chrysler.


What kind of Engine coolant for a 1993 Chrysler New yorker?

Green


How do you drain the radiator on a 1993 Chrysler new yorker?

To drain the radiator of a 1993 Chrysler New Yorker, you have to open the petcock on the radiator completely and drain the coolant into a container.


Does a 1993 Chrysler new yorker's transmission fit a 1995 dodge grand caravan with a 3.3 motor?

If the New Yorker has a transverse engine, also a 3.3, then yes it should fit.


What AC refrigerant is used in a 1993 Chrysler new yorker?

R134a


Does a 1993 chrysler new yorker have air suspension shocks?

It could,


What type of oil does my 1993 Chrysler new yorker use?

5w30


Where is the transmission filter on a 1993 Chrysler New Yorker?

It is inside the transmission pan.


What motor oil should you use in 1993 Chrysler new yorker?

10w30


Are there vacuum lines for a 1993 Chrysler New Yorker that would keep it from shifting?

No.


Where is the fuel pump on a 1993 Chrysler new yorker?

It is inside the fuel tank.


How do you invoke the computer relearn cycle on a 1993 Chrysler New Yorker Fifth?

To invoke the computer relearn cycle on a 1993 Chrysler New Yorker Fifth, first, disconnect the negative battery cable for about 10 minutes to reset the engine control module (ECM). Reconnect the battery, then start the engine and allow it to idle for approximately 10 minutes without any load, which helps the ECM recalibrate. Afterward, take the vehicle for a short drive, varying speeds and engine loads to complete the relearn process. This should help the ECM adjust to new sensor readings and optimize engine performance.