I don't think you can adjust it. I think the computer controls it. If you're having an idle problem it may be the TPS sensor or a tune up.
you will need to have your computer reprogramed to adjust timing,fuel mixture etc
The fuel mixture is controlled by the computer and is not adjustable.
torque specs air fuel mixture screw on a yz125 2003
adjust the two fuel screws all the way in and adjust a half turn out until you get it right
The CBR 100 RR is a fuel injected bike, you can not adjust the air fuel mixture, however if you change the exhaust you can sometimes get an aftermarket programmer that will re-map the fuel and timing. Hope this helps!
To adjust the air and fuel mixture on a Nissan Terano, you typically need to access the carburetor or the fuel injection system, depending on the model year. For carbureted models, you can adjust the mixture screws located on the carburetor. If it's a fuel-injected model, you might need to use an OBD-II scanner to check the air-fuel ratio and potentially adjust the fuel pressure regulator or replace the air filter. Always refer to the vehicle’s service manual for specific procedures and settings.
They are to adjust the air/fuel mixture.
Fuel mixture can not be adjusted it is computer controled.You can adjust the idle by removing the cover where throttle cable attaches to the throttle body and turning adjustment screw
need to know how to make adgustment
drivers side underneath right in front of the rear tire.
100:1
The 1998 Chevrolet Camaro with a V6 engine produces approximately 190 horsepower. This engine is a 3.8-liter V6, which was known for providing a balance of performance and fuel efficiency for the model year.