to adjust idle on 2000 impala....Locate the accelerator cable on the throttle body.Have someone push down on the accelerator pedel while you observe the throtle body cable movements.You will notice a stop screw on the throtle body butterfly where it comes to rest against the throtle body.Turn the screw clockwise for more rpm, turn the screw counter clockwise for less rpm. I am not sure if any of the air filter componets need to be removed or not... Should't have to do this.Observe...you can do it...
Idle speed is controled by the computer, therefore non adjustable.
You don't, fix the vacuum leak that's causing the eratic idle conditions
The 2000 Chevrolet Impala parking brake will have an adjustment bolt on the parking brake assembly. Turn the adjustment bolt to loosen or tighten the parking brake.
You have two adjusting screws at the top of the dieselpump. And the outer screw is for idle if i dont remember wrong. but that you will notice when you adjust the screw.
the idle is set by the comp so u need some sort of programmer
To adjust the idle on a 2000 Polaris Magnum, first, locate the idle adjustment screw on the carburetor. Start the engine and let it warm up to operating temperature. Then, while the engine is running, turn the idle adjustment screw clockwise to increase the idle speed or counterclockwise to decrease it, until the desired idle speed is achieved. Finally, ensure the engine runs smoothly without stalling at the adjusted idle.
You adjust idle with idle timing
Adjust idle on Mitsubishi diamante
there is a screw on the carb. be sure to adjust while the engine is running so you can tell by the idle when it is set properly.
There is an adjustment screw that sits against the "dashpot" and you turn it right (in) to lower the idle and left (out) to raise the rpms.
how to adjust idle on 2001 legacy
you can adjust it via the idle control valve.