you don`t know?
It is on the side of the throttle plate right across from the accelerator cable.
check cable under seat to see if it is ok! the one going to seat lever. if nessesary replace cable.
The shift linkage on your Chevrolet Blazer automatic transmission will go from the shifting handle to the right hand side of the transmission. The shifting linkage is actually a shifting cable.
IDK who would know that only nerds not popular people like me!
Shorten it to make it downshift sooner. Lengthen it to downshift later at a higher power setting.
On the pump there are two line marks,one on the lever the other on the the body. These twomarks must line up at an idle position. The end of the cable housing will have a threaded end with two nuts used to adjust the cable.
To adjust the automatic clutch cable on a 1999 Citroën Xsara 1.4, first, locate the cable near the clutch pedal. Check for any slack in the cable and ensure the pedal has the correct free play (typically around 1-2 cm). If adjustment is needed, use the adjusting nut on the cable to increase or decrease tension until the proper play is achieved. Finally, ensure everything is securely fastened and test the clutch operation before driving.
my cable was capable of that much adjustment
Chevrolet Blazer parking brake can be adjusted with the adjustment screw on the parking brake pad. The parking brake can also be adjusted with the parking brake cable.
There is none it is electric.
To adjust the throttle cable, first open the hood of the car and locate the cable. Then, adjust the screws on either side of the cable. Following that, tighten the cable so that it is taut and there is no slack, but it is not over tight.