answersLogoWhite

0

There is a rubber hose beside the master cylinder, with a round fittin in the end of it. take a straight bit screw driver, with engine running,loosen and let it bleed the air out . re tighten.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you bleed the cooling system on a 2002 Kia Sedona EX?

Your ''KIA'' dealer,or eBay


Where is the air bleed on a 2002 Lincoln ls?

On a 2002 Lincoln LS, the air bleed valve is typically located on the engine's cooling system, specifically near the thermostat housing. To bleed air from the system, you can loosen the valve while the engine is running and at operating temperature, allowing trapped air to escape. Be sure to monitor the coolant level and add coolant as necessary to prevent overheating. Always consult the vehicle's service manual for specific procedures and safety precautions.


How do you bleed or burp air from engine cooling system on 2002 Oldsmobile silhouette?

It should have a bleeder screw on top of the thermostat housing.


Where are the air bleeder plugs located on a 2002 Saturn cooling system?

The air bleeder plugs on a 2002 Saturn cooling system are typically located near the highest points of the system, such as near the radiator or on the engine block. They are used to release any air trapped in the system to ensure proper coolant circulation. Consult your vehicle's manual for specific locations.


Is there a coolant air bleed valve on a 2002 Mazda 626?

Yes, the 2002 Mazda 626 does have a coolant air bleed valve. This valve is typically located on the engine's cooling system and is used to release trapped air from the coolant system during maintenance or after a coolant change. Properly bleeding the coolant system helps ensure efficient engine cooling and prevents overheating. Always refer to the vehicle's service manual for specific procedures and locations.


What is the cooling system capacity for a 2002 Pontiac Bonneville SE?

Per the 2002 Bonneville Manual the cooling system holds 10 quarts.


Where is the thermostat on 2002 Chrysler concord?

The thermstat is on the bottom hose. The flow of water is opposite of most other cars. Don't forget to bleed the cooling system when you fill it back up.


Why is water gettin in your 2002 Lincoln ls v8?

i have a 2002 lincoln navigator an when i put water in the resevru for cooling it leck out with out the truck running . were can this water come from


What is the cooling system capacity of a 1972 BMW 2002?

My data give 7.00Ltrs as the cooling system capacity.


How do you burp or bleed the cooling system 2002 Buick rendezvous?

To burp or bleed the cooling system of a 2002 Buick Rendezvous, start by ensuring the engine is cool and the radiator cap is removed. Fill the radiator with coolant and run the engine with the heater set to the maximum setting, allowing air to escape as the engine warms up. Keep an eye on the coolant level, adding more as necessary until all air bubbles are gone and the coolant stabilizes. Finally, replace the radiator cap securely once the system is free of air.


Where can you find a parts diagram for a 2002 Ford Focus cooling system?

wiring wire harness cooling sistems ford focus 2002


How do you bleed the cooling system on a 2002 GMC sonoma?

don't tighten the rad cap all the way, only to the first natch so it is secure but moves like it is loose, will allow air to excape or just normally run the engine as you normally would to heat it up and it will bleed its self