0
What else can I help you with?
How do you bleed air from a 2006 Chevy impala 3.5 cooling system?
there should be a air valve on the engine that you can bleed the bubbles out of the cooling system.
How do you bleed air out of cooling system Chevy Blazer 4.3?
If the cooling system is in good working order the system will bleed the air out itself. If the system has a leak anywhere no matter how small the system will never bleed the air out.
How do you bleed the air from the Engine cooling system on Chevy truck?
Engine cooling system is not a closed system you can't remove the air.
How do you bleed cooling system 2005 Chevy Equinox?
Cut it's throat!
How do you bleed the air out of a 1993 Lumina Z34 cooling system?
You'll need a vacuum pump that is used by AC service technicians.
How do you bleed the air out of a cooling system on a 1990 Chevrolet Lumina with a 3.1L engine?
On top of the thermostat housing is a bleed valve. Loosen the top nut first, this will bleed it. There is another one on the radiator, but I haven't found it yet.
Where is the air bleed valve for the cooling system on a 2004 Chevy impala?
It is a brass fitting on the top of the thermostat housing.
How do you get heat in a 1990 Chevy Lumina APV if replacing the thermostat did not help?
Make sure antifreeze level is not low. And also "bleed" air from the cooling system. Look for bleeders where water hoses enter the engine. (might be one right on the thermostat housing).
How do you bleed the cooling system 1995 Nissan questafter the thermost has been replaced?
There is no reason to ever bleed a cooling system.
When do you bleed a radiator 1996 Monte Carlo ls?
Any time you flush out the cooling system you need to bleed the cooling system.
1988 Acura Legend bleed cooling system?
How do you bleed the cooling system of a 1988 acura legend? Is there a bleeding screw and where is it located?
How do you bleed cooling system on a 1998 Chevy lumina with a 3.1 engine?
there is a bleeder valve just behind the water pump. it takes a 1/4 inch socket or wrench. start the engine then loosen bleeder this will allow the fluid though your system. when you get fluid coming out without air you should be set. good luck.
