0
To change the coolant temperature sender on a 1992 Ford Ranger with a 3.0 engine, first ensure the engine is cool and disconnect the negative battery cable. Locate the coolant temperature sender on the engine block, typically near the thermostat housing. Use a wrench to unscrew the old sender and then install the new one, being careful not to overtighten. Finally, reconnect the electrical connector and the negative battery cable, and check for leaks after refilling any lost coolant.
What else can I help you with?
Where is the coolant temperature sensor for a 1997 Ford Ranger?
Which engine do you have?
Where is the coolant temperature sending unit on a 2005 ford ranger?
The Engine Coolant Temperature sensor can be found near the thermostat housing or close to where the upper radiator hose attaches to the intake manifold. Good luck.
Where is the coolant temperature sensor for a 1999 ford ranger?
on the front, top of the engine. look near the upper coolant hose on the engine for a sensor with a couple of wires on it. There may be 2 in close proximity that look similar.
Where is temp sending unit on 2004 ford ranger?
The Cylinder Head Temperature (CHT) sensor for the 2.3L engine is located between the two center ignition coils. The Engine Coolant Temperature (ECT) sensor for the 3.0L engine is located in the intake manifold to the right of the thermostat housing. The Engine Coolant Temperature (ECT) sensor for the 4.0L engine is located in the intake manifold behind the thermostat housing.
Coolant Temperature Sensor ford ranger?
on top of the engine on the hose that outlets from the pipe going to the thermostat. it has two spade terminals and is easy to access right there in the middle of the engine bay
Need to drain the engine coolant where are the engine plugs on a 1990 ford Ranger?
You drain coolant from the radiator. but according to the book ther are two plugs on the engine block that need to drain the coolant from.
What does the check gauge light mean on a 2002 Ford Ranger?
On a 2002 Ford Ranger : The check " gage " light comes on if : The engine coolant temperature is TOO HIGH The engine oil pressure is TOO LOW or The fuel gauge is at or near empty
What type of coolant was originally put in a 98 Ford Ranger?
The 1998 Ford Ranger Owner Guide shows Ford Extended Life Engine Coolant ( Dexcool )
Where is the radiator cap to add coolant on a 2003 Ford Ranger?
On a 2003 Ford Ranger : The 2.3 litre four cylinder engine has a thread on cap on the engine coolant reservoir , that is the pressure cap / radiator cap ----------------------------------------------------------------------------------------------------- On the 3.0 and 4.0 litre V6 engines , I believe there is a radiator cap on the top of the radiator , but with the engine cool you should add engine coolant to the engine coolant reservoir - it has a cold fill mark
How much coolant does a ford ranger radiator hold?
The coolant capacity of the Ford Ranger is dependent on model year and engine type. The latest model year of the Ford Ranger was 2011. The 2011 Ranger with the 4. 0L V6 and the automatic transmission had a coolant service fill of 13. 2 quarts.
Why is the gauge light on in 1999 ranger xlt?
The check gage light comes on if your engine coolant temperature is high , the oil pressure is low , or the gas tank is almost empty
What does it mean when the check gage light comes on a 2001 ford ranger?
Either your engine coolant temperature is HIGH , your oil pressure is LOW , or your gas tank is at or near empty
