To change the crankshaft on a 1994 Mercury Sable 3.8, first disconnect the battery and remove the engine from the vehicle. Drain the oil and coolant, then remove the timing cover, oil pan, and any components obstructing access to the crankshaft. After removing the main bearing caps and the old crankshaft, install the new crankshaft, ensuring proper alignment and torque specifications for the bearing caps. Reassemble all components in reverse order, refill with oil and coolant, and reconnect the battery.
No, the 1994 Mercury Sable does not use R12 for recharging the A/C unit. The 1994 Mercury Sable uses R134a Freon.
Yes , a 1994 Mercury Sable is a front wheel drive vehicle
In a 1994 Mercury Sable : " regular " unleaded gasoline , 87 octane
what is the cost to replace the rack and pinion on a 1994 mercury sable
We recommend every 30,000 miles.
on the steer wheel
A code 111 on a 1994 Mercury Sable is a KOER code. This specific code means that no other codes are coming up on the vehicle.
Inside the transmission
I cant remember if a 1994 had a distributer or not. If it has a distributer, there is no crankshaft position sensor. That information is a calculated value using the input from the distributer stator(pickup coil). If there is no distributer, then there will be a crank sensor on the front of the engine down by the crank pulley.
The transmission dip stick on a 1994 Mercury Sable is located on the driver's side of the motor. It has a white-handled ring and it is about midway between the radiator and the back fire wall.
look in the glove box
I was looking at one of the Ford websites and it shows for a 1994 Mercury Sable ( Motorcraft FG-800-A engine fuel filter , all engines , without flex fuel )