0
To change the Low Beam headlight bulb on a 2004 Chevrolet Epica you need to:
1) Remove the 3 bolts (Metric size 10) holding the headlight assembly in place. There are 2 at the top and one on side beside the grill.
2) Gently start to slide the whole assembly out, while lifting slightly to get over the bumper.
3) Unplug the signal light to allow you to get additional length. (There is a little pressure connection you push in to allow you to unplug the signal light).
4)Without the signal light wire attached you can swing the whole unit out towards the grill and rest on the bumper.
5) Slide the two retainer clips holding the back cover of the headlights to their respective sides.
6) Removing the cover will expose the high/low beam light bulb. It is held in place by a wire and secured by two Phillips screws. Loosen the screw closer to the grill. Be-careful as it is under a bit of pressure.
7) Once loose enough you can pry the wire out and the bulb is freed.
8) Put in new bulb, be careful not to touch the glass part of the bulb.
9) Secure the wire again, and tighten the Phillips screw.
10) Replace the cover and slide the two clips into place
11) Check the high beam connection to ensure it has not disconnected or come loose.
12 Slide the assembly back towards proper place so you can hook up the signal light.
13) Slide into place, there are two plastic pegs that need to slide into their respective holes as you slide the assembly back into place.
14) Put in the three bolts and tighten.
15) Test the lights to ensure everything is working.
Presto, you've likely spent approximately 10-15 minutes and saved yourself $30-$50 and a ton of time at the garage or dealership.
What else can I help you with?
How do you change rear brakes 2004 chev epica?
There's no such thing as a Chevy Epica...
How do you remove the headlight lenses on a 2004 Chevrolet Cavalier?
hammer
How do you change a headlight on a 2004 cavalier?
To change a headlight on a 2004 Chevrolet Cavalier, first, open the hood and locate the headlight assembly. Disconnect the wiring harness by pressing the tab and pulling it away. Remove the retaining clip or screws holding the headlight in place, then carefully pull the headlight out. Replace it with a new bulb, ensuring it is securely fitted, then reattach the wiring harness and reassemble any clips or screws.
How do you change a 2004 Nissan altima headlight bulb?
My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb? My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb?
Is there a fuse for the headlight on a 2004 Saab 95?
== == That is how you change the actual headlight but the question is how to change a fuse.
Where is drl module for Chevy epica located?
The drl module on chevy epica 2004 is back to the data link connector
Where is the transmission fill plug on a 2004 Chevrolet epica?
On a 2004 Chevrolet Epica, the transmission fill plug is typically located on the side of the transmission case. You'll need to access it from beneath the vehicle, and it often has a hex or square shape for turning. Ensure the vehicle is on a level surface and that the engine is off before attempting to check or add transmission fluid. It's advisable to consult the vehicle's service manual for specific details and procedures.
How do you replace the headlight bulk on a 2004 Hyundai 2004 XG350L?
How do you change a headlight bulb on 1 2004 Hyundai XG 350?
How do you change headlight 2004 Mazda 6?
* *
How do you Change Windshield Wiper Blades on a 2004 Chevrolet Trail Blazer?
How do you Change Windshield Wiper Blades on a 2004 Chevrolet Trail Blazer?
Where is the headlight relay switch located on a 2004 Chevrolet Cavalier?
there is two of them one is infont of radiator on frame
How do you change headlight bulbs on a 2004 Mazda 3?
Nicole
