(1)Remove the door trim panel; (2)disconnect the electrical connector for the power mirror (3) where necessary, lower the window for access to the mirror mounting nuts (4)remove the mounting nuts and take the mirror out. - Haynes Ford Ranger Pickups Repair manual
On a 1996 Ford Ranger ( fuse # 1 is a 7.5 amp mini fuse for the power mirror ) The fuse panel is in the drivers end of the dash , the fuse panel cover is visible with the drivers door open
you get someone to do it for you.
Remove the inside door panel of your Chevy Cavalier. Remove the drivers side mirror wiring harness, if the mirror is electric. Remove the drivers side mirror retaining bolts. Reverse the process to install the new drivers side mirror.
how to install Ford Ranger Driver Side View Mirror
In the US, yes, a drivers mirror is required.
You must remove door panel to acess bolts that secure mirror to door. Remove all parts securing mirror and install in reverse order with new mirror.
on the 88 ranger the switch is above your rearview mirror located on the ceiling on the 88 ranger the switch is above your rearview mirror located on the ceiling
To change a wing mirror on a Rover 25, start by removing the interior door panel to access the mirror's mounting screws. Disconnect the electrical connector if your mirror is powered, then unscrew the mirror from the door. Replace it with the new mirror by securing it with screws and reconnecting the electrical connector, if applicable. Finally, reattach the door panel and ensure everything is properly aligned and functioning.
remove drivers inside door panel and there are 2 or 3 bolts that hold mirror on from the inside after you diconnect the wire harness if it is a power mirror
From the Haynes Repair Manual for Ford Ranger Pickups 1993 - 2005: "(1)remove the door trim panel; (2)disconnect the electrical connector for the power mirror (if equipped). NOTE: on 1998 and later models, remove the watershield and speaker to get to the electrical connector for power mirrors; (3)where necessary, lower the window for access to the mirror mounting nuts; (4)remove the mounting nuts and take the mirror out; (5) installation is the reverse of the removal steps". A picture shows that the mounting nuts are accessible through three holes in the door panel. Hope this helps. Good luck.
Silver
convex mirror as used by drivers in different vehicles......