I would clean the grease off of the commutator and brushes and put a 3/4" drywall screw through the thermal switch. All of these things are inside the motor. there is no need to remove the motor or regulator. Instead, remove the end cap ( where it plugs in) and pull out the guts of the motor ( end cap, brushes, springs and armature). Note the rotational position of the armature where it comes out of the motor easily. After repair, preassemble the guts ( paying attention to the rotational position of the armature) and reinstall into the motor.
The power window fuse for a 1994 Lumina APV is located on the passenger side. It is in the fuse box behind the glove box.
you dont rotate it you have to pull the altnator off to change them
It does not have a carburetor.
Chevrolet Lumina APV was created in 1989.
If the motor has been replaced and the window still does not operate properly there is likely a wiring issue. The wiring from the fuse box to the window motor is likely the culprit.
Engine does not have to be removed.
4.7 that's 4 quarts 7 oz.
I think the module is in the distributor with two phillips screws
if you need a good ground. you can use a good bolt under hood or similar.
under the engine
Get a syphon hose
Spark Plugs on a LuminaSee the related questions to the right. HOW DO YOU CHANGE THE SPARKS PLUGS ON A 1993 CHEVY LUMINA APV 3.8L 231-V6 ENGINE (an van)