0
To change the ignition switch on a 1992 Buick Roadmaster, start by disconnecting the negative battery cable to ensure safety. Remove the steering column covers, then locate and unbolt the ignition switch, which is typically mounted on the steering column. Disconnect the wiring harness from the old switch, install the new ignition switch in its place, reconnect the wiring, and reassemble the steering column covers. Finally, reconnect the battery and test the new switch.
What else can I help you with?
Location of fuel switch for 1986 Buick roadmaster?
The Buick Roadmaster was not produced in 1986. They were made from 1991 to 1996.
How do you change the key ignition in a 1992 Buick Roadmaster?
The answer to this is too complex and you need special tools...sorry..Rick D
How do you replace an ignition switch 93 Buick roadmaster?
fuel pump keeps running after the key is out what do I need to check I have to remove the fuses to stop the pump.
How do you change ignition switch on 1998 Buick century Do you have to remove the steering wheel?
do I remove steering wheel to change out ignition
Where is the fuel cut off switch on 1992 Buick roadmaster?
A 1992 Buick does not have an inertia or fuel cut off switch.
Where us the fuel reset switch located on a Buick Roadmaster?
It is not equipped with an inertia switch.
Replace ignition switch for 1993 Buick century?
Replace ignition switch for 1993 buick century?
How do you replace the coil on a 1994 Buick Roadmaster?
Ignition CoilEngine LH Side Upper
How to replace 1996 Buick Skylark Ignition?
Ignition what? Switch? Coil?
What does the 09 diagnostis code mean on a Buick Roadmaster climate control switch?
Low freon
How do you open Buick roadmaster heater blend doors?
How to unlock a buick roadmaster
How do you turn out the change oil light on a1995 Buick Roadmaster?
A. Here you go. This works on the 1996 model Change Oil or Change Oil Now Message: # Turn ignition switch to ON position, without starting engine. # Press accelerator pedal to wide open throttle (WOT) position and release three times within five seconds. # If Change Oil warning indicator goes out,system has been reset. # If Change Oil warning indicator does not reset, turn ignition switch Off and repeat procedure.
