Remove wheel, remove the bolt holding brake hose to the caliper, remove the two pins that hold the caliper to the caliper bracket using a 3/8" allen wrench, remove caliper. Inspect brake pads and brake hose for damage, replace if necessary. Install new brake caliper in reverse order. Bleed system.
Remove the tire and wheel from your 1996 Chevy Cheyenne. Remove the brake spring and the break caliper. The brake pads will come off. Reverse the process to install the new brake pads.
That's what I am asking you. How do you replace a parking brake handle on an S-10 1996 Chevy Blazer?
The brake dump valve on a 1996 Chevy Suburban is used for bleeding the brakes after new brake pads are installed. It is located on the master cylinder for each brake.
You should be able to find a shop manual for this at the local library...make copies of the right pages...)
1996 Chevy blazer timing chain
possible air in the brake lines.
how to change a superten belt on a 1996 Chevy s 10
It could be low on brake fluid, a sign of trouble. Have the brakes checked SOON!
do you mean cavalier hand brake?
55 ft. lbs.
on the brake pedal under the dash there will be a king pin pull it out and remove the stud and the switch should come right out then dosconnect the wireing harness and replace switch
Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier