Remove the interior door panel. The handle is accessible by reaching through the door frame, but it is difficult if you have large arms/hands.
The handle is secured to the door with two screws. The screws can be removed best with a socket on the end of a 6" extender. There are holes in the sheet metal that allow direct access to the screws with the socket.
With the screws removed, you need to disconnect the latch pushrod, and remove the key lock barrel before the handle will come out of the door.
The pushrod attaches to the handle with a plastic clip. You have to rotate the plastic clip away from the rod, then the rod will pull out of the hole on the handle.
The lock barrel is secured with a U-shaped spring clip. Remove the clip with a screw driver and push the barrel out the back of the handle.
With the lock and pushrod detached, you may still have to pry a bit on the handle to get it out of the hole in the door.
To re-install the handle, reverse the process. Make sure to re-attach the lock and the latch pushrod before securing the handle with the two screws. It's almost impossible to get the lock and pushrod installed once the handle is screwed to the door.
Where is the fuel filter located in a 1999 oldsmobile aurora
1998 olds aurora altenator replcemnt
Under the rear seat.
The 1999 Oldsmobile Aurora oil filter can be found on the left-hand side of the engine. The oil filter will be near the oil pan.
On my aurora, I just hold in the reset button.............
Under the back seat.
Oldsmobile did not build an Aurora in 2000. Is your car a first generation 1995 to 1999, or is it a second generation 2001 to 2003.
Top Back part of Motor
Lick it.
The cost of replacing the wheel bearings on a 1999 Oldsmobile Aurora is about $120. This depends on the hourly cost of the mechanic.
On my 1998 Aurora with a 4.0L V8, the water pump is on the driver's side of the engine. It is right at the top of the engine.
Disk brakes on rear? My 96 aurora was simple The disk brake slave cylinder has to be screwed in after you get the caliper off. After that its just like any other disk brake pad replacement