To change the driver side headlight on a 1992 Plymouth Acclaim, first, open the hood and locate the headlight assembly. Remove the retaining clips or screws that hold the headlight in place, then gently pull the assembly forward. Disconnect the wiring harness from the back of the headlight bulb, replace the old bulb with a new one, and reassemble by reversing the steps. Make sure to secure everything tightly and test the new headlight before closing the hood.
The diagnostic connector for a 1994 Plymouth Acclaim is located under the dashboard on the driver's side. Specifically, it is typically found near the steering column, often mounted on or near the fuse box. This connector is used for connecting a diagnostic scanner to retrieve trouble codes from the vehicle's onboard computer system.
you need a small arm
On the driver's side. Sit in the car and it is right in front of your left knee closest to the door. It is clearly marked "Fuse Access".
On the transaxle(transmission) bell housing, on the driver's side. there should be a little window cut out on the top there are some notches there. That's the timing marks.
Pull the hood release lever near the parking brake on the bottom of the driver's side dash. Push the lever under the hood up and push up on the hood.
In a 1991 Plymouth Acclaim, one flasher is located in the fuse box, typically found under the dashboard on the driver's side. The second flasher is usually located near the steering column, often mounted on or near the ignition switch or behind the dashboard. To access it, you may need to remove panels or covers around the steering area.
The fuel pump fuse for a Plymouth Acclaim is typically located in the fuse box, which is found under the dashboard on the driver's side or in the engine compartment. To identify the specific fuse for the fuel pump, consult the diagram on the fuse box cover or refer to the owner's manual for the exact fuse number and rating. It's important to check that fuse if you're experiencing fuel pump issues.
To change headlight bulbs in a 2005 Ford Escape, first make sure the light switch is in off position and replace the passenger light bulb. Next, get to the driver's side bulb, remove the battery by holding it down, to be able to change the headlight bulb.
Work from behind light fixture Remove wire clip and twist bulb to remove Note: The above only works for the passenger's side headlight. The driver's side light is harder to get to. To replace the driver's side headlight remove the battery and it's hold down.
go from underneath it takes probably 2 minutes to do both
On your 1995 PLYMOUTH TRUCK VOYAGER 2WD, the COMPUTER CONTROL is: UNDER HOOD, DRIVER SIDE, FRONT SIDE OF STRUT TOWER, REAR OF HEADLIGHT, MOUNTED ON INNER FENDERWELL You can find this stuff free at Autozone.com under component location.
9004 for main headlights. H3 (35watts) for foglights located next to headlights. To change passenger-side headlight, remove the airfilter box, disconnect the headlight socket, unscrew the black ring that secures headlight bulb. To change the driver's side, repeat the same procedures.