Find the ABS wheel sensor. Loosen the bolts that attach it to the suspension. Remove the bolts that hold the sensor to the wiring. Remove all other bolts. Remove the ABS sensor.
if it`s the front abs sensor you will need to buy the hub bearing,as this is all one unit.
Need to change the whole bearing...
To change the ABS wheel sensor on the driver front, start by safely lifting and securing the vehicle. Remove the wheel to access the brake assembly, then locate the ABS sensor, usually mounted near the brake rotor. Disconnect the electrical connector and unscrew the sensor from its bracket. Install the new sensor by reversing these steps, ensuring it's securely fastened and the connector is properly attached before reassembling the wheel.
how to replace front abs speed sensor
There is just a rear one I believe, on top of differential
It is screewed into the top rear of the transfur case.
rear abs sensor is in the transfer case in the rear tailshaft there 2 sensors 1 is for the speedo and 1 for the abs
A 4 wheel abs would have sensor wires running to the front wheel bearings.A 4 wheel abs would have sensor wires running to the front wheel bearings.
Have 1996 ranger4wd front abs sensor frozen on spindle any suggestions
Where is the answer
95 Chevy Tahoe no rear brake have hard peddel bleed all the lines when i disconcet front line to abs i have rear brakes concet front line i have no rear but have front is my abs valve screwed up
Typically at the brake rotor. It is a magnetic hall-effect sensor that usually reads off of the wheel bearing or the CV.