answersLogoWhite

0

remove steering wheel , there is an little botton in the colum to push ine when igntion is turned to the on position , then pull on igntion .

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Will 85 ford bronco tailgate fit 89 ford bronco?

Yes. The Bronco body style didn't change again until after 1989.


Replacing ignition lock and tumbler on 85 rx7?

phone me 604 649 8449.


How do you remove ignition switch on a 85 bronco 2?

To remove the ignition switch on a 1985 Bronco II, first disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing the screws that hold it in place. Next, locate the ignition switch, which is typically mounted on the steering column; unscrew it and disconnect the wiring harness. Finally, pull the ignition switch out from its position for replacement or repair.


How do you change the ignition switch in a 1985 Chevy Cavalier?

i have 85 cavalier how you get key cycliner out


What is the best way to get the ignition lock out without keys The owner had no keys to this 85 Fiero.?

Keys are not necessary, but is not a DIY procedure. Contact a locksmith or mechanic


How can you start an 85 Sunfire without keys and a secondary lock in the ignition?

Hey Duster, remove steering wheel, remove the lock plate, this require a special tool, the ignition tumbler id held by a torx bolt, and it will slide out.. get a manual for any Gm car of that vintage....hope thuis helps..


Is the width of a f350 dashboard the same width as a bronco 85 model dash?

no


What is the maximum speed of the ford bronco 8cyl 156hp 1978?

85 mph


What is the maximum speed of Ford Bronco 1978?

Top speed is 85 mph.


Will a 1985 ford bronco tailgate fit on a 1993 ford bronco Eddie Bauer?

probably not since the 96 is a little narrower than the 85 i would say no


Why wont your 85 bronco start without starting fluid?

sounds like its not getting fuel


Will a 85 ford truck body fit on a 85 bronco frame?

The cab and front sheet metal will fit but you will have to bobb your bed about 11 inches shorter.