All I can tell ya is to cry, yell, scream, fork out money and for Gods sake, BUY NEW INTAKE ISOLATOR BOLTS. That is your coolant loss and rough idle comes from.
Remove the 1995 Oldsmobile Cutlass intake manifold retaining bolts. The manifold will come off. Remove the old gasket. Clean the surface. Put the new intake gasket and tighten the intake manifold retaining bolts.
i am replacing the starter on olds 1995 aurora
Remove the intake manifold, exhaust manifold, and then remove the head. Scrap off the old gasket and install a new one. Reinstall the head and Torque the head bolts in the proper sequence. Reinstall the intake and exhaust manifold torque the bolts to the proper torque. This is a major repair and not for a novice to try.
Blown intake manifold gasket or blown head gasket, figure on $600 to $650 to get intake gasket fixed and if a head gasket your looking at least $1,000.
How do I change the head gasket on a 1995 Park Avenue. and what are the specs.
Intake & exhaust manifold must be removed. Then the head must be removed. head inspected for cracks or warping, and new head gasket installed. Not a repair for a novice.
under the intake manifold
On a 1995 GMC Jimmy with a Vortec engine, the fuel injectors are located within the intake manifold, specifically under the upper intake manifold assembly. To access them, you typically need to remove the air intake assembly and the upper intake manifold. The injectors are mounted directly to the lower intake manifold and are connected to the fuel rail, which supplies them with fuel.
There is no difference,,,
The intake manifold is underneath the plastic silver cover held down by four nuts. Take it off and you'll find the intake manifold - also plastic. Even more unusual, the starter is underneath the intake manifold!
you have to remove the intake manifold , the starter is under the intake ,but first disconnect the negative battery cable. that's all i know on this subject.
you must remove upper intake manifold to access these plugs