To change the radiator hose on a 1995 Cadillac Seville SLS, first ensure the engine is cool and disconnect the negative battery terminal. Drain the coolant from the radiator, then loosen the hose clamps on both ends of the old hose and remove it. Install the new hose by securing it to the radiator and engine, tightening the clamps, and refill the coolant before reconnecting the battery. Finally, start the engine and check for leaks.
Probably at the engine end of the upper radiator hose
Follow the top radiator hose down to the water outlet. The stat is in there. Let me know if this helps you. Mark
In a 1995 Cadillac Seville, the thermostat is typically located near the engine, specifically at the engine's front, where the upper radiator hose connects to the engine block. To access it, you will usually need to remove the upper radiator hose and the thermostat housing. It's advisable to consult the vehicle's service manual for detailed instructions and diagrams to ensure proper handling.
REMOVE LOWER RADIATOR HOSE AND REMOVE THE TWO BOLTS HOLDING THE FLANGE TO WATER PUMP HOUSING AND TSTAT IS RIGHT THERE
The cost to replace the lower radiator hose on a 1996 Cadillac Seville STS typically ranges from $100 to $200, including parts and labor. The hose itself may cost between $20 and $50, while labor charges can add another $80 to $150, depending on the shop's rates. It's advisable to get a few quotes from local mechanics for a more accurate estimate.
You have to pull the lower radiator hose to drain/flush the radiator
To remove the radiator from a 1999 Cadillac Seville, first, ensure the engine is cool and disconnect the negative battery terminal. Drain the coolant by removing the drain plug or lower radiator hose, then disconnect the upper and lower radiator hoses. Remove any mounting bolts or clips securing the radiator, and detach the transmission cooler lines if applicable. Finally, lift the radiator out carefully, ensuring no components are damaged in the process.
Drain the radiator by removing the lower hose. Then remove the fan shroud then the oil cooler lines and upper hose/ Then the bolts that hold it in and pull it out. Dispose of the used coolant properly.
Engine end of the upper radiator hose
fallow the radiator hose under the air filter. you will have to lift the air filter. It's right there. the thermostat is locted on the intake on the left hand side in the rear of tne engine.
Disconnect the lower hose
First you get to it then you remove it