Access to the bulbs is easy. They are removed from inside the trunk. Fold back the trunk liner(carpeting) and twist the individual bulb holder to remove it. Then you will see the bulb and twist it to remove it from the holder.
If your that stupid you don't need to be driving
Who to Change engine check light bulbs on a 1996 BMW 318i?
If the turn signal bulbs work but just do not flash, replace the Flasher Relay.
If its the same as the mark viii then you would have to replace the bulb by removing the light that is held in with 4 or 5 screws then you can take out all wires and bulbs you need to.
It's what you use to signal to go left or right.
To replace the turn signal switch of a 1996 Dodge Caravan, open the engine's hood to access the front turn signal bulbs. Then take the headlight assembly a little off the front to give room to get the bulbs. Remove the old turn signal switch and slip the new one in place.
Check the bulbs Check the flasher
There is not a flasher on a 1996 Lincoln Town Car. The turn signal and hazard flashers are operated by what is referred to as the lighting control module. It is located in the dash behind the knee bolster above the accelerator pedal.
Check bulbs - double filamented with smaller being for brake light and turn signal Bad switch? Bad turn signal flasher?
The headlamp bulbs on a 1996 Acura TL are installed from the engine bay. Find the housing located in the front of the vehicle. Disconnect the bulbs and replace them with new units.
It's incorporated in the turn signal stalk.
You have to open the hood, unscrew the front turn siganls, remove the bulbs, remove the bolts holding on the grill, release the 2 bottom tabs of the grill(through the turn signal holes), make sure marker lights are disconnected and remove the grill. undo 4 bolts on each headlight assembly and remove/change/replace the bulbs. Intallation is reverse.