You have to pull the radio trim, instrument cluster trim & top center heat/ac vent.
After these are out you can remove the 3- 7mm screws from the back holding the switch in.
The turn signal flasher relay switch and the emergency flasher relay switch are the same switch. The relay switch might be labeled as the emergency flasher switch, but it is also the signal flasher relay switch.
The emergency flasher switch on the 2009 Cobalt is located behind the steering wheel.
The 2001 Monte Carlo emergency flasher relay switch and the turn signal flasher relay switch are the same. The flasher relay switch simply plugs in and out.
Its in the emergency flasher module in the dash. The module is the same as the switch you toggle to turn the emergency flasher on/off.
Its in the emergency flasher switch. Mounted in the dash.
Yes, as long as they have the same part number and many do.
The turn signal switch in the colum could be bad COULD B the TurnSignal switch OR the Flasher 4 the Emergency FLASHERS (because there is 2(two) Flashers & the Brake light Switch on the Brake pedal could B Bad.(turnsignals Have there OWN Flasher) the emergency flasher switch has 3 electrical contacts.sometimes they overheat and melt into the red flasher switch deforming the whole switch.unfortunatly the whole blinker and flasher needs to be replaced.
Behind the hazard switch in the dash
It is right behind the hazard flasher switch on the dashboard, remove the air outlet to the right of it, just pops out with a straight screw driver. The switch /flasher is a solid state device.
check the flasher itself and the switch
the signal flasher is the hazard light switch......remove the radio bezel and change the switch
Usually part of the switch (module)