0
To change the expansion valve on a 1997 Pontiac Grand Am, first, ensure the AC system is fully discharged to avoid refrigerant exposure. Remove the dashboard or access panel to reach the expansion valve, typically located near the evaporator core. Disconnect the refrigerant lines and electrical connections from the old valve, then install the new valve in reverse order, ensuring all seals are secure. Finally, recharge the AC system and check for proper operation.
What else can I help you with?
Where is the expansion valve located on a 1995 Pontiac grand am?
where is the expansion valve located
Where is the PCV valve located on a 1998 Pontiac Grand AM?
on a 1998 Pontiac gan am ,they do not have a pcv valve.
Where is valve cover located on a 2001 Pontiac Grand-am 4-cylinder?
where is valve cover located on a 2001 Pontiac Grand-Am 4 cyl
Where is the egr valve on a 2004 Pontiac Grand Am?
does a 2004 grand am ,2.2 l have a egr valve
How do you replace egr valve on 2004 Pontiac grand am?
location of egr valve on 04 grand am v6
Where is the heater control valve on a 1996 Pontiac Grand Am?
Where is the the heater control valve??
Where is the PCV valve located on a 1991 Pontiac Grand Am?
=== === === ===
How do you replace valve lifters on a Pontiac Grand Am?
how to replace lifters on a 03 grand am
How do you change the expansion valve on a 2001 Honda Civic?
How do you change the ac expansion valve on a 2001 Honda civic
Where is the EGR Valve located on a 2000 Pontiac Grand Am 2.4 4 cylinder?
The EGR valve is located on the side of the intake on the 2000 Pontiac Grand Am. It is close to the intake manifold.
Where is the PCV valve located on a 1990 PONTIAC Grand Prix?
The PCV valve is located under the MAP sensor on a 1990 Pontiac Grand Prix. The MAP sensor is in the upper plenum.
Is a 1999 Pontiac Grand Am 4 cylinder engine interchangable with a 1995 Pontiac Grand Am 4 cylinder?
yes the motor will fit in the car chassis but u might have to change all the wiring harness's because i am pretty sure that, that motor is a 24 valve...but if a 16 valve came out of the 95 and ur putting a 16 valve into the 95 u shouldn't have to change the wiring harnesss
