0
Start by locating the sensor. It will be located on the side wall of the Head. searching an internet based image search will show you where its located. Secondly, disconnect the sensor wire harness. Take the appropriate wrench and loosen the sensor. Grab the sensor with you'r hand and phisically pull back, pulling the sensor compleatly out of the engine head. Discard the old sensor, that is unless you need the sensor to take to the parts store for a core refund, but useally these sensors are worthless. Take the new sensor and reverse the process. Push the sensor into place. Tighten with the same wrench as used before, and replace the wire harness. There we go, all done, oh and that pesky light that won't go off, you guessed it, back to the parts store to have the nice man in the bow tie to take the scanner and eliminate the light. The only problem is, is that these type of sensor rarley malfunction or go bad. You may have an engine knock and not know it. It is possible.
What else can I help you with?
How do you change the knock sensor in a 2003 Chevy Silverado 5.3?
how do you change the knock sensor in a 2003 Chevy silverado 5.3
Where is the knock sensor in a 2003 gm sierra?
under the intake manifold just had new ones put in +2003 6.o Chevy
Where is the knock sensor on a 2003 KIA?
where is knock sensor on 2003 kia sorrento ex located
Where is the anti-knock sensor on a 2003 Chevy Avalanche?
you mean knock sensor
How long does it take to replace knock sensor on 2003 Kia spectra?
Where is the knock sensor for a 2003 kia spectra
How do you change the knock sensor on a 2003 Chevy Avalanche?
That engine has 2 of them and you MUST remove the intake manifold to service the knock sensors.
Location right bank knock sensor 2003 5.3?
location right bank knock sensor 2003 5.3 z71
How to change a knock sensor 2003 dodge caravan?
you unplug the old one. And plug in the new one.
Diagram for the location of a knock sensor on a 2002 Chevy Tahoe.?
2003 chevy tahoe knock sensor
Where is the knock sensor on a 2003 gmc sierra with a 4.8 liter?
There are 2 of them and you are not going to belive this, but both of them are underneith the intake manifold. You can't see are get to them until you remove the intake.
How do you change the knock sensor on 2003 jaguar s type 3.0?
To change the knock sensor on a 2003 Jaguar S-Type 3.0, first, disconnect the negative battery terminal to ensure safety. Then, remove the intake manifold to gain access to the knock sensor, which is typically located on the engine block. Unscrew the old sensor, replace it with the new one, and reconnect any wiring. Finally, reassemble the intake manifold and reconnect the battery.
Where is the knock sensor on a Kia Sedona?
where is the knock sensor on 2003 kia Sedona answer knock sensor is mounted on the engine block near the intake manifold with a wiring harness attached to it.
