0
What else can I help you with?
How do you change the sending unit on a 1991 4 cylinder ford ranger?
Do you mean the Temp sending unit, oil pressure sending unit, or fuel level sending unit?
How do you install a sending unit in a 83 Chevrolet pick-up?
There are several sending units in that vehicle such as the fuel sending unit, the oil pressure sending unit, the temperature sending unit. Need to know which one you want to change.
What does the code p0522 mean for 2003 PT Cruiser?
it means low voltage on the oil pressure sender circuit, most likely a bad oil pressure sending unit.
Will a bad oil sending unit on a 2005 Chrysler pt cruiser cause engine not to start?
No. The oil pressure sensor is not required for the engine to run.
Where is the oil pressure sending unit on a 2003 Chrysler PT cruiser?
The oil pressure switch is in the middle of the engine, back side, a little left about half way up the engine.
Would the oil sending unit on a Chrysler pt cruiser cause it not to start?
No.
How do you Remove oil pressure sending unit on 2.7 liter Chrysler engine?
Remove the oil pressure sending unit retaining ring. Remove the wiring harness from the sending unit. Poll the sending unit out of the engine.
How do you change 96 cadillac deville sending unit seal?
Oil pressure sending unit is located by oil pan in front. Unplug unscrew and install new one
How do you change the oil pressure sending unit on a 1991 S10 2.5L?
To change the oil pressure sending unit on a 1991 S10 2.5L, first ensure the engine is cool and disconnect the battery. Locate the oil pressure sending unit on the engine block, typically near the oil filter; unplug the electrical connector and remove the unit using a socket or wrench. Install the new sending unit, reconnect the electrical connector, and reconnect the battery. Finally, start the engine and check for any leaks.
Where is the oil pressure sending unit 05 gmc sierra?
The oil pressure sending unit on a 2005 GMC Sierra
Where is oil pressure sending unit for 1998 Mitsubishi mirage?
Were is the oil pressure sending unit on a 95 mitsubishi miaage
Where does the hot wire lead to from the sending unit on a 1986 Chevy s-10 pickup?
Which sending unit? Oil pressure sending unit? Engine temp sending unit? Fuel gauge sending unit?
