To change the rear brakes on a 1996 Oldsmobile Achieva, start by safely lifting the vehicle and removing the rear wheels. Next, remove the brake caliper by unbolting it, then slide it off the brake rotor. Replace the brake pads by removing the old ones and installing the new ones, ensuring to compress the caliper piston if necessary. Finally, reassemble everything by reinstalling the caliper, wheel, and lowering the car. Make sure to pump the brake pedal before driving to ensure proper brake function.
It is built in to the rear window along with the rear defroster.
How do I change rear breaks on a 2003 tracker 6cyl 4x4? the axle is in the way...
I have a 94 Achieva that did the same thing. It was a bad light switch. Replaced the light switch and have had no problems since'
Go to www.autozone.com. they have online repair manuals for free and you can look up anything. i just looked up diagram of my rear brakes under the repair section.
remove wheel
replace the rear breaks
The 1996 Oldsmobile Achieva typically has three motor mounts: two side mounts and one rear mount. These mounts help secure the engine and minimize vibrations. It's important to check their condition, as worn mounts can lead to excessive movement and noise.
the gas tank is located at the rear of the car on the bottom. Its apx. under the back seats or trunk. you can see it if you look up under the car from the outside.
There are two reasons for this. The first is the break calibers need bled and the second is the breaks themselves need adjusted back.
It could be your rear breaks / including the emergency breaks, or your rear differential
please help im dumb
my breaks stuck after we got the four wheeler back from a crapy mechanic. how do i get the drum off to free the breaks ?